China atlas copco air compressor service Manufacturer, Supplier, Factory

Atlas Copco Air Compressor Shaft Sleeve Oil Seal Kit C55 Oil Shaft - Importance Although the shaft sleeve oil seal kit is a small component, it directly affects the operating cost and reliability of the compressor: Leakage will lead to increased lubricant consumption, environmental dirtiness, and even serious faults such as bearing wear of the main unit and rotor sintering due to lack of oil. It is recommended to replace it with the original Atlas Copco C55 kit to ensure the matching accuracy and sealing performance with the main unit.

Maintenance Tips for Atlas Copco's Minimum Pressure Valve Regularly check if the valve is leaking (by listening or measuring pressure). If there is a leak, it may be due to worn seals or impurities blocking the mechanism. In such cases, clean or replace the components promptly. When replacing, ensure that the model matches the original factory model to guarantee that the pressure setting value, interface size, and the compressor system are consistent. Avoid poor lubrication or reduced system efficiency due to parameter mismatch. Before restarting after a long shutdown, manually check the flexibility of the valve core to prevent sticking due to oil residue solidification. The Atlas Copco minimum pressure valve, as the "pressure stabilizer" and "check valve" of the compressor oil circuit and gas circuit, is crucial for the safe operation and lifespan of the equipment. It is recommended to use original factory parts to ensure system compatibility and reliability.

Maintenance tips for Atlas Copco air compressor thermostat kit: Regularly remove the thermostat valve for cleaning, remove foreign substances that may exist in the lubricating oil, and prevent blockage. You can put the valve core in 80℃ water to observe. If the valve core expands fully in this environment and is 10-15mm longer than at normal temperature, then the valve core is normal. If there are aging or other issues, the thermostat valve needs to be replaced.

Maintenance Points: The coupling of Atlas Copco air compressors usually requires regular checks on the wear condition of its elastic elements, the tightness of the connecting bolts, etc. Some models of air compressors also have coupling cooling fans to help lower the operating temperature of the coupling and extend its service life. During maintenance, the working condition of the cooling fans also needs to be checked.

High quality filtration The configuration and careful selection of the filter materials is key to all filters performance, ensuring maximum filter lifetime, minimal pressure drop and optimal quality of the outlet air.Prevent contamination All our filters are designed for your compressor and ensure a perfect fit preventing unfiltered air or oil from passing through.Reduce oil consumption Low oil carry over keeps your oil consumption to a minimum.

Atlas Copco Installation and Maintenance Tips Installation Requirements: The metal sealing surfaces must be thoroughly cleaned (free of oil stains and scratches), and the fastening bolts must be tightened uniformly to the specified torque (usually 30-50 N·m) to ensure that the sealing elements are fully in contact. Cleaning Cycle: Depending on the operating environment, the metal filter element should be back-flushed for cleaning every 2000-4000 hours (using dry compressed air to blow from the inner side of the filter element outward). An ultrasonic deep cleaning should be performed after a cumulative operation of 10000 hours. Replacement Criteria: When there is local damage to the filter element (detected through an endoscope) or permanent deformation of the sealing element surface (resulting in an excessive leakage rate), the corresponding components should be replaced promptly.