China atlas copco air compressor for sale Manufacturer, Supplier, Factory

Atlas Copco Fan Motor The fan motor of the air compressor is a key component in the cooling system of the air compressor. Its main function is to drive the fan to rotate, and it cools the compressed air, lubricating oil or the body of the air compressor through forced air cooling, ensuring that the equipment operates stably within an appropriate temperature range.

2205684100 Drain Valve: This automatic drainage valve provides a fully automatic drainage function for the water collected at the lower level of the compressed air system. Its maximum working pressure is 20 bar, and the drainage capacity is 0.88 US gallons per minute. The interface is G1/2.

If the muffler is clogged or damaged, it will cause an increase in intake/exhaust resistance, which may affect the gas production efficiency of the air compressor. Regular inspection and maintenance are necessary. For large air compressor systems, it is recommended to adopt comprehensive noise reduction measures such as soundproof rooms and vibration isolators for better results.Well-known brands (such as Atlas Copco, Ingersoll Rand, etc.) all have corresponding air compressor mufflers. Depending on the specific model, original factory parts or third-party products that meet the specifications can be selected.

Atlas Copco Maintenance Tips: Regular Inspection: Remove the cylinder cover and clean the valve surface of oil stains and carbon deposits (especially for piston-type air compressors, as high-temperature lubricating oil can easily cause carbon deposits); Replace Wear Parts: Valve plates, springs, sealing gaskets, etc. are considered wear parts. When wear, deformation or aging is detected, they should be replaced in time; Keep Clean: Avoid introducing impurities during installation. The filter device of the intake system needs regular maintenance to reduce dust entering the cylinder. Although the cylinder cover valve is a small component, it directly affects the compression efficiency and operational stability of the entire machine. During daily maintenance, special attention should be paid to its sealing performance and operational flexibility. If any abnormalities occur, timely repairs should be carried out to extend the service life of the air compressor.

Atlas Copco 2202207986 is made of high-strength cast iron and steel. It has sufficient rigidity and wear resistance, and is suitable for the long-term high-speed operation range of 500 - 3000 rpm of the machinery.

Replacement and selection suggestions for flat washers of Atlas Copco air compressors When replacing, it is necessary to strictly match the original specifications to avoid sealing failure or connection loosening due to size mismatch. For high-pressure, high-temperature or areas in contact with compressor oil, it is recommended to use original factory metal flat washers to ensure that the material is oil-resistant and pressure-resistant. If it is a critical sealing part (such as the end cover of the oil-gas separator), check whether the surface of the washer is flat, without scratches or deformation. If necessary, replace the new part to ensure the seal. For specific models or part numbers, you can refer to the parts manual of the air compressor (usually identified by a numerical code, such as 0650 series, 1622 series), or consult the Atlas Copco after-sales service for the equipment model to obtain precisely matched parts.