Air compressor spare parts

Atlas Copco WUX Regulator Valve Maintenance and Precautions Regular Inspection: Observe whether the valve operates smoothly and check for any sticking (possibly caused by oil contamination or impurities); Check the sealing performance. If there is air leakage (such as air flowing through when the valve is closed), replace the sealing element. Cleaning and Calibration: Regularly disassemble and clean the valve core, valve seat, and diaphragm, removing oil stains and carbon deposits; Calibrate the pressure setting value according to the equipment manual to ensure adjustment accuracy (avoid excessive pressure fluctuations). Replacement Suggestions: If the valve cannot be adjusted, has severe air leakage, or suffers mechanical damage, it should be replaced promptly (it is recommended to use original factory parts to ensure compatibility with the compressor control system).

Atlas Copco Air Compressor Shaft Sleeve Oil Seal Kit C55 Oil Shaft - Importance Although the shaft sleeve oil seal kit is a small component, it directly affects the operating cost and reliability of the compressor: Leakage will lead to increased lubricant consumption, environmental dirtiness, and even serious faults such as bearing wear of the main unit and rotor sintering due to lack of oil. It is recommended to replace it with the original Atlas Copco C55 kit to ensure the matching accuracy and sealing performance with the main unit.

ATLAS COPCO PT1000 Operating Instructions Operators should be familiar with the meanings of fault codes (refer to the equipment manual) to quickly identify and solve problems. The adjustment of key parameters such as pressure should be within the rated range of the equipment to avoid overpressure operation and potential safety risks. Regularly check the connection lines of the controller to prevent signal transmission interference caused by vibration and oil contamination.

Attention to the Atlas Copco Adsorption Dryer Silencer: During installation, ensure that the sealing gasket is intact to prevent air leakage, which could lead to increased noise and reduced regeneration efficiency; Do not replace it with an incompatible model at will (for example, if the diameter is too small, it will cause excessive exhaust resistance, affecting the regeneration effect of the adsorbent); The original factory silencer is usually designed with acoustic optimization, not only providing better noise reduction effects, but also ensuring the smoothness of the regeneration exhaust and maintaining the normal cycle of the dryer.

Application scenarios and maintenance for Atlas Copco KIT THERM MPV C40 Applicable models for Atlas Copco KIT THERM MPV C40: Mostly used in medium-sized oil-lubricated screw compressors of Atlas Copco (such as some models of the GA series), especially suitable for working conditions with high requirements for pressure stability and oil-gas separation efficiency (such as precision manufacturing, food and pharmaceutical industries). Maintenance points: Atlas Copco KIT THERM MPV C40: Regularly check for any leakage in the valves (judged by the rate of pressure drop); Clean the valve cores and sealing surfaces to avoid jamming caused by oil stains and impurities; If the temperature sensing element fails, it needs to be replaced in time to maintain the constant temperature control function.

ATLAS COPCO GA160 Operating Instructions Before operation, please read the equipment manual to avoid mistakenly modifying critical parameters (such as excessive pressure limit). When a red fault alarm occurs, stop the machine for inspection first, eliminate the fault, and then restart it. Regularly clean the control panel to prevent dust or oil stains from affecting the sensitivity of the buttons.