China Atlas Copco Air compressor Oil Filter Manufacturer, Supplier, Factory

Atlas Copco 1631090801 Pipe G 1/4X245, G1/4 interface size, G represents imperial non-threaded sealed pipe thread, the thread size is 1/4 inch, 245 represents the pipe length.

Maintenance and Replacement Suggestions for Air Filters of Atlas Copco Screw Air Compressors Replacement Cycle: Generally, it is recommended to replace the air filter according to the specified cycle in the equipment maintenance manual (such as after 2000-4000 hours of operation, which may vary depending on the model and usage environment). If the dust concentration in the usage environment is high (such as in mines or cement plants), the replacement cycle should be shortened. Inspection Method: Regularly (e.g., weekly) check the cleanliness of the air filter. You can determine if it is clogged by using a pressure differential indicator (available on some models) — when the indicator value exceeds the set threshold, it is necessary to replace it promptly. Replacement Precautions: During replacement, ensure proper installation and good sealing; avoid allowing impurities to fall into the intake pipe during disassembly and assembly. After replacement, check for any leakage.

Atlas Copco Maintenance and Replacement Guidelines Synchronous Replacement: It is recommended to replace the air filter, oil filter, and lubricating oil at the same time to reduce the oil pressure difference and energy consumption. Installation and Sealing: Install according to the manual torque. Replace all O-rings to avoid bypass of unfiltered air or oil. Pressure Difference Monitoring: Pay attention to the oil pressure difference and fuel consumption. If it abnormally increases, stop the machine for inspection and replacement. Environment and Load: In high dust / high humidity or heavy load conditions, the replacement cycle can be shortened to 3500 - 4000 hours or less.

Maintenance recommendations for pressure sensors of Atlas Copco air compressors: Regularly check if the sensor wiring is secure and clean the oil stains on the probe surface. Calibrate the sensors regularly according to the equipment manual to ensure measurement accuracy. In case of failure, replace the original factory parts (such as Atlas Copco original sensors) first to avoid compatibility issues affecting the performance of the unit.

ATLAS COPCO "8000 Hours Service Maintenance Kit" Purchase and Replacement Key Points Verify "Model + Serial Number" to confirm the part number with the service manual and the spare parts list. Prefer original factory or certified accessories. Replace according to the steps in the service manual. Pay attention to torque, sealing, exhaust and fluid replenishment procedures. After completion, record and reset the maintenance timer. In harsh environments or high-load conditions, it can be shortened to 6000 - 7000 hours; pay attention to condensation and drain valve maintenance in humid environments. If abnormal sounds, vibrations, temperature or pressure occur after replacement, immediately shut down the machine for inspection and contact the service team.

Synchronous replacement: If you need to replace the belt, it is recommended to also check the wear condition of the pulley at the same time. If necessary, replace both the new and old parts synchronously to avoid abnormal wear caused by improper fit between the new and old components.