China Air compressor Ordinary Oil Filter Manufacturer, Supplier, Factory

Atlas Copco Air Compressor Shaft Sleeve Oil Seal Kit C55 Oil Shaft - Importance Although the shaft sleeve oil seal kit is a small component, it directly affects the operating cost and reliability of the compressor: Leakage will lead to increased lubricant consumption, environmental dirtiness, and even serious faults such as bearing wear of the main unit and rotor sintering due to lack of oil. It is recommended to replace it with the original Atlas Copco C55 kit to ensure the matching accuracy and sealing performance with the main unit.

Procurement and adaptation confirmation of Atlas Copco air compressor spare parts 2901077901: We suggest purchasing original kits from our distributors to ensure filtration accuracy, size matching, and material reliability. If you need to confirm if it is compatible with your device, please provide the complete model and serial number of the air compressor and contact us for further verification.

Selection and precautions for the oil-water separator of Atlas Copco G series air compressors The oil-water separator should be selected based on the specific model (such as G37, G75) and displacement of the G series air compressor to ensure that the processing capacity matches. It is recommended to use the original Atlas Copco oil-water separator and filter element. Their materials (such as the filter element using high-efficiency fiberglass or polyester materials) and structural design are fully compatible with the G series models, which can ensure separation efficiency and service life, and avoid secondary pollution or excessive pressure loss caused by compatibility issues.

Maintenance and Care Regularly replace filters: air filter, oil filter, oil-gas separator. Prevent impurities from entering the system. Check the lubricating oil: oil level, oil quality (oxidation, emulsification). Replace the oil according to the manufacturer's recommended schedule. Clean the cooling system: For air-cooled models, clean the radiator regularly; for water-cooled models, check the water quality and temperature. Tighten bolts: Prevent vibration from causing bolts to loosen, which may lead to safety hazards. Monitor operating parameters: Regularly record exhaust temperature, pressure, current, etc. Address any abnormalities promptly.

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.

New jet screw, oil-free screw, centrifugal compressor, ROTZ, screw, centrifugal blower; After treatment dryer, cooling dryer, filter; Pressure swing adsorption nitrogen machine; In addition, controller expansion has been optimized, and energy recovery equipment and over 20 new products will be provided simultaneously.