China Atlas Copco 2906049700 Manufacturer, Supplier, Factory

Usage and Maintenance Notes Strictly match the model Different series of air compressors (such as GA, GHS, ZR, etc.) require the use of corresponding model-specific oils. Mixing or using the wrong type may cause equipment damage and affect warranty. Regular replacement and inspection Replace according to the specified cycle in the equipment manual (synthetic oil usually has a longer cycle than mineral oil), and replace oil filters, air filters, etc. at the same time. Regularly test the oil quality (such as viscosity, moisture content, impurity content) to avoid failures caused by deteriorated oil. Storage and refilling The oil needs to be stored in a sealed manner in a cool and dry place to avoid contamination; when refilling, ensure that the tools are clean to prevent impurities from entering the oil circuit system.

The oil cooler of Atlas Copco air compressor GA132 functions as follows: The oil cooler is used to cool the lubricating oil during the operation of the air compressor, absorbing the heat from the compressed air that the lubricating oil has absorbed, and ensuring that the temperature of the lubricating oil remains within an appropriate range, thereby guaranteeing the normal operation and lubrication effect of the air compressor.

Note: Replacement cycle: The sealing ring is a wear-prone component. It is recommended to conduct regular inspections and replacements as per the instructions in the equipment maintenance manual to prevent leakage due to aging or wear, which could cause equipment malfunctions.

Fault and Replacement Suggestions: If the fuel injection valve becomes clogged, stuck, or leaks, it may cause the following issues: Insufficient fuel injection: Poor lubrication of the main engine, increased temperature, leading to rotor wear or abnormal noise; Excessive fuel injection: Increased oil content in the compressed air, heavier load on the oil separator, and increased energy consumption; Uneven fuel injection: Insufficient lubrication in some parts of the rotor, resulting in uneven wear or overheating. Suggestions: During daily maintenance, check if there is any oil accumulation on the fuel injection valve and clean the filter regularly (if applicable); When encountering abnormal engine temperature, increased fuel consumption, or abnormal noise, promptly inspect the condition of the fuel injection valve;

Atlas Copco Air Compressor Oil Check Valve Maintenance and Replacement Check Period: It is recommended to conduct checks every 1-2 years or in accordance with the equipment manual (for example, after 4000-8000 hours of operation), and perform the checks simultaneously when replacing the filter and oil. Maintenance Points: Clean the valve core and valve seat to remove impurities; Check the wear of the seals and replace them promptly if they are aged; Test the elasticity of the springs. If the elasticity is insufficient, replace the entire valve. Replacement Precautions: Select original factory parts that match the model (such as Atlas Copco, Ingersoll Rand, etc. have dedicated oil check valves). Ensure that the size and pressure parameters are consistent; Pay attention to the direction during installation, and avoid installing it in the wrong direction; After replacement, start the equipment and check if the oil circuit pressure is normal and if there is any leakage.

The main function of the Atlas Copco temperature sensor is to monitor the temperature of critical parts in real time. When the temperature exceeds the safety threshold (usually above 85-100℃, depending on the model), it will trigger a protection mechanism to stop the air compressor, preventing equipment damage. During normal operation, if the temperature is within the normal range of 65℃, no special treatment is required; regular maintenance is sufficient.