China Atlas Copco 0663313000 Manufacturer, Supplier, Factory

Applicable models The Z series oil-free centrifugal compressors of ATLAS COPCO, such as ZB VSD⁺ oil-free magnetic suspension centrifugal blower, ZM oil-free multi-stage centrifugal blower, ZHL single-stage centrifugal compressor, etc., as well as the GT, T, RT and other series process gas compressors, all come with corresponding impeller components.

Key points for replacement and maintenance: When replacing, the oil separator filter element should be replaced simultaneously. Also, check if the sealing gasket is aged. If necessary, replace it together to ensure a proper seal. Before installation, clean the oil stains and impurities on the interface surface. Tighten according to the specified torque to avoid over-tightening which may cause the shell to deform or under-tightening which may lead to leakage. Regularly (usually in accordance with the filter element replacement cycle, approximately 2000-4000 hours) check if there are any cracks, corrosion or deformation in the shell. Replace it promptly if any abnormalities are found.

If you need to purchase or replace the air compressor head of this model, it is recommended to do so through our Atlas Copco dealers to ensure the authenticity of the parts and the subsequent installation, after-sales support. At the same time, when replacing the air compressor head, professional technicians are usually required to operate to ensure the installation is in accordance with specifications and avoid affecting the normal operation of the air compressor.

First separation: The oil-gas mixture containing various-sized oil droplets, which comes out from the exhaust port of the air compressor main unit, enters the oil-gas tank. Most of the oil in the oil-gas mixture falls to the bottom of the tank under the action of centrifugal force and gravity. Second separation: The compressed air containing oil mist passes through the micrometer and fiberglass filter material layers of the oil-gas separation filter element for secondary separation. The oil particles undergo mechanisms such as diffusion, direct interception, and inertial collision aggregation, causing the suspended oil particles in the compressed air to quickly coalesce into large oil droplets. Under the action of gravity, the oil gathers at the bottom of the oil separation element and returns to the main lubricating oil system through the bottom concave area of the secondary return oil pipe inlet, thereby enabling the air compressor to discharge more pure and oil-free compressed air.

Common Problems and Maintenance of Atlas Copco Oil Separator Reduced separation effect Reason: Filter blockage, damage, poor return oil pipeline, or excessively high temperature of the oil-gas mixture . Solution: Replace the filter, clean the return oil pipe, and check the cooling system to ensure the exhaust temperature is normal . Excessive pressure difference Sign: The pressure difference between the separator inlet and outlet exceeds 0.15MPa, resulting in reduced exhaust volume and increased energy consumption. Solution: Replace the filter in time to avoid filter damage or overload of the housing due to excessive pressure difference. Return oil failure Reason: Return oil valve blockage, throttling hole blockage, or leakage of the return oil pipe. Harm: The compressor operates without oil, causing wear of the main unit and sudden temperature rise. Solution: Disassemble and clean the return oil components to ensure smooth return oil.

Atlas Copco Z160-275 transmission shaft bearing kit usage and maintenance precautions: When replacing, it must be operated by professional technicians. Follow the steps in the equipment maintenance manual strictly to ensure that the bearings are installed properly and the clearance is adjusted reasonably. Before installation, clean the transmission shaft and bearing housing, and check whether the relevant mating surfaces are intact to avoid impurities or damage affecting the bearing lifespan. It is recommended to conduct regular inspections in combination with the overall maintenance cycle of the equipment. If abnormal bearing noise or abnormal temperature rise is detected, the kit should be replaced promptly.