China Air Compressor Pressure Sensor Manufacturer, Supplier, Factory

Atlas Copco Air Compressor Oil Separation Filter Purchase Recommendation To ensure the separation effect and equipment safety, it is recommended to purchase the original factory oil separation cores through our authorized dealers. Using inferior substitute filters may result in insufficient separation efficiency, short lifespan, and even damage to the main unit, thereby increasing maintenance costs. The performance of the oil separation filter directly affects the operating efficiency, energy consumption, and downstream gas quality of the air compressor. It is a component that needs to be focused on during maintenance.

Maintenance and servicing tips for the tubular coolers of Atlas Copco compressors: Regular cleaning: Depending on the operating environment, clean the inside and outside of the cooling tubes of the tubes and the sealing surfaces of the caps (using chemical cleaning or mechanical flushing) to prevent a decline in heat exchange efficiency. Leak detection: Check for any leaks at the pipe connections and sealing surfaces of the caps. Replace the seals or repair damaged pipes in a timely manner. Flow monitoring: Ensure that the flow and pressure of the cooling medium (water or air) are within the specified range. If insufficient, investigate pipe blockages or pump/fan failures. Anti-freezing protection： In low-temperature environments， after shutdown， drain the accumulated water in the cooling water pipes to prevent cracking due to freezing.

Atlas Copco "Wear Kit" Replacement and Maintenance Recommendations Replacement Timing: Triggered by service manual or when pressure difference/temperature abnormalities occur; Replace along with filters and lubricating oil to reduce energy consumption and failure risks. Installation and Sealing: Tighten according to torque, replace all O-rings/ seals, avoid unfiltered air or oil bypass. Recording and Warning: Update maintenance records, activate pressure difference/ hourly/ status indicator and remote alarm to shorten downtime response.

Maintenance Key Points for Worm Wheel Type Impellers in Atlas Copco Centrifugal Air Compressors Regular Inspection: Use endoscopes or shut down for disassembly to check if there are cracks, wear, deposits, or foreign object impact marks on the impeller surface. Special attention should be paid to the blade roots (stress concentration areas). Dynamic Balance Calibration: If the impeller shows slight deformation or wear after long-term operation, it may cause dynamic balance imbalance. Re-calibration is necessary to avoid excessive vibration of the shaft system. Replacement Standard: When the impeller has irreparable cracks, severe damage to the blades, or the dynamic balance cannot be adjusted to the qualified range, it is necessary to replace the original factory impeller in time to ensure the matching and operational safety of the unit.

2901023100 Atlas Copco GA30-45GBD series oil-injected screw compressors. "GA" refers to the classic series of Atlas Copco fixed screw compressors. 30-45 represents the power range of approximately 30-45 kW, and GBD is a specific configuration code.

Maintenance Recommendations: Regular Inspection: Conduct an inspection every 3-6 months (or as per the equipment manual) to check if the muffler is damaged in appearance, or if the connection parts are loose or leaking air. Cleaning and Replacement: Shorten the maintenance cycle based on the operating environment (such as in areas with high dust or high humidity). In cases of severe blockage, disassembly for cleaning or direct replacement may be necessary. Compliance Replacement: Only use original or certified alternatives to ensure compatibility with the equipment's exhaust volume and pressure parameters, to avoid reduced equipment efficiency or safety hazards due to size mismatch.