China 2902015300 Atlas Copco Manufacturer, Supplier, Factory

As a high-efficiency air compression equipment, the core working principle of a rotary screw air compressor is through two carefully designed rotors - a male rotor (male rotor) and a concave rotor (female rotor) - inside the casing.

Maintenance suggestions: During installation, it is necessary to check whether the sealing surface of the flange is in good condition. Use the original factory sealant gasket and tighten the bolts according to the specified torque. This is to prevent air leakage or damage to the components due to improper installation.

The Atlas Copco 2901069502 kit is designed for use for up to 4000 hours or one year. However, the lifespan of the air filter depends on the quality of lubrication and the environmental conditions.

Atlas Copco Air Compressor Shaft Sleeve Oil Seal Kit C55 Oil Shaft - Importance Although the shaft sleeve oil seal kit is a small component, it directly affects the operating cost and reliability of the compressor: Leakage will lead to increased lubricant consumption, environmental dirtiness, and even serious faults such as bearing wear of the main unit and rotor sintering due to lack of oil. It is recommended to replace it with the original Atlas Copco C55 kit to ensure the matching accuracy and sealing performance with the main unit.

Atlas Copco Common Problems and Solutions Slip and Abnormal Noise: This is often caused by loose belts, oil contamination, or wear on the pulley grooves. Adjust the tension, clean, or replace the pulley. Excessive Breakage: This may be due to excessive tension, incorrect belt type, misaligned pulley grooves, or excessive load. Check and adjust as necessary. Severe Heating: This is usually caused by slipping or poor heat dissipation. Stop the machine immediately for inspection.

Atlas Copco Maintenance and Replacement Recommendations Replacement Cycle: it is recommended to replace the filter according to the specified cycle in the unit maintenance manual . If the dust concentration in the usage environment is high, the replacement cycle should be shortened . Condition Judgment: Some models are equipped with an air filter pressure differential indicator. When the indicator value exceeds the set threshold, it indicates that the filter is clogged and needs to be replaced immediately; without an indicator, regularly disassemble and inspect the accumulated dust on the filter material surface. If it is obviously clogged or damaged, replace it immediately. Replacement Precautions: Before replacement, the unit must be shut down and the power disconnected to ensure safety. During installation, clean the impurities around the air inlet to avoid contaminants from falling into the air intake pipe during disassembly and assembly.