China Atlas Copco 2902015300 Manufacturer, Supplier, Factory

The oil filter models corresponding to different models of the XAS series air compressors vary. Common oil filter models include 1613610500, 97125402, 9709003400, 9710009801, 1613610500, etc. (The specific model needs to be determined according to the specific model of the air compressor.)

Maintenance and servicing tips for the tubular coolers of Atlas Copco compressors: Regular cleaning: Depending on the operating environment, clean the inside and outside of the cooling tubes of the tubes and the sealing surfaces of the caps (using chemical cleaning or mechanical flushing) to prevent a decline in heat exchange efficiency. Leak detection: Check for any leaks at the pipe connections and sealing surfaces of the caps. Replace the seals or repair damaged pipes in a timely manner. Flow monitoring: Ensure that the flow and pressure of the cooling medium (water or air) are within the specified range. If insufficient, investigate pipe blockages or pump/fan failures. Anti-freezing protection： In low-temperature environments， after shutdown， drain the accumulated water in the cooling water pipes to prevent cracking due to freezing.

1900071151 The working principle of the regulator for Atlas Copco centrifugal air compressor ZH10000: The inlet regulating vane mechanism adjusts the air flow and pressure entering the compressor by changing the angle of the vane. It can maintain a constant pressure within the adjustable range. This mechanism is installed within an effective range of 1-1.5 times the pipe diameter from the impeller. It can save a significant amount of energy within the adjustable range of 65% - 100% of the air volume.

6229031700 The non-return valve C77 of the oil-injected screw compressor from Atlas Copco reduces the impact of the backflow airflow on the internal components of the compressor, such as rotors and bearings, thereby extending the service life of the equipment.

The main function of the Atlas Copco temperature sensor is to monitor the temperature of critical parts in real time. When the temperature exceeds the safety threshold (usually above 85-100℃, depending on the model), it will trigger a protection mechanism to stop the air compressor, preventing equipment damage. During normal operation, if the temperature is within the normal range of 65℃, no special treatment is required; regular maintenance is sufficient.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.