China screw air compressor thermostat valve Manufacturer, Supplier, Factory

Faults and Maintenance Suggestions Common Problems and Solutions: Poor or blocked drainage: This is often caused by accumulated impurities. You can disassemble the valve body to clean the filter screen. In severe cases, the original valve needs to be replaced. Valve always closed or always open: This may be due to a fault in the electromagnetic valve coil or damage to the controller. You need to check the circuit and replace the corresponding components. Leakage: Caused by aging seals. It is recommended to directly replace the entire drainage valve (the original kit includes all seals). During maintenance, it is necessary to regularly (every 3 months) check if the wiring is loose, clean the drainage outlet, ensure that the winter environmental temperature is not lower than 0℃, and prevent freezing and cracking.

The Atlas Copco MK5 control panel, through an integrated design, simplifies the operation of the air compressor and enhances the reliability and energy efficiency of the system. It is widely used in industrial production scenarios where the stability of compressed air supply is highly demanded. The specific functions may vary slightly depending on the model of the air compressor. It is recommended to operate in accordance with the equipment manual.

Procurement and adaptation confirmation of Atlas Copco air compressor spare parts 1635316600: It is recommended that we purchase the original spare parts through Atlas Copco to ensure that the size and filtering accuracy match the equipment. If you need to confirm whether it is compatible with your air compressor, please provide the complete model and serial number of the equipment and contact us for further verification.

Replacement and Maintenance Precautions: If cracks, deformations, damage to the sealing parts, or worn-out connection threads occur on the shell, it must be replaced immediately. Otherwise, unfiltered air will directly enter the main unit, causing wear and tear on components such as rotors and bearings. During daily maintenance, it is necessary to check whether the seal between the shell and the filter element is intact, and clean the dust and impurities inside the shell (especially when replacing the filter element). When installing a new shell, ensure that the sealing ring is installed properly, and tighten the connecting bolts according to the specified torque to avoid air leakage or damage to the shell due to vibration.

How to choose (quickly) Specify the model: Fixed oil injection screw (GA/GX etc.) or mobile air compressor. Key points of working conditions: Ambient temperature, pressure level, whether it is hot / humid / dusty, whether it is in contact with food. Prioritize original factory oil: Highly compatible with seals, oil separation, oil filters and temperature control valves to reduce the risks of oil bubbles, carbon deposits and abnormal fuel consumption.

The significance of maintaining the oil filter of Atlas Copco air compressors By strictly following the 2000-hour replacement cycle (or adjusting according to actual working conditions), it is possible to ensure that the oil filter always remains in an efficient filtering state, preventing impurities from entering the main unit and causing wear on the screws and bearings. At the same time, it can reduce the rate of lubricating oil deterioration and extend the service life of the unit. The structural design of the original factory oil filter (such as check valves and bypass valves) can also provide reliable protection during the replacement cycle, and is a fundamental maintenance step for ensuring the long-term stable operation of the air compressor.