China Oring Manufacturer, Supplier, Factory

Atlas Copco 1625752501 Notes for Attention Original Equipment Advantage: The original equipment corresponding to this part number is fully compatible with the equipment in terms of size accuracy and filtration efficiency, ensuring the best filtration effect and reducing the risk of equipment damage caused by compatibility issues. Confirm Compatibility: Since the same part number may correspond to a specific model, before replacement, it is necessary to check the model and serial number of the air compressor, or consult an authorized Atlas Copco dealer to ensure the compatibility of the parts.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.

Atlas Copco 2906049900,The principle of the air compressor maintenance kit: Replace worn parts, perform maintenance and troubleshooting, ensure safety,Air filter element Remove garbage from the bottom. The filter with grease needs to be soaked in foam-free detergent. Damaged filters need to be replaced. Oil separator To ensure high efficiency of oil-gas separation, it is necessary to pass the compressed gas from the collision and gravity separation compressor through the oil separation process. Safety valve It is necessary to ensure the quality and safety of pressure vessels. Professional adjustments are required. Lubrication system Test the oil quality with screw oil and maintain the lubrication of bearings and the lifespan of the compressor Maintenance process standardization 1. Shut down and power off: Turn off the power and hang warning signs 2. System depressurization: Close the water supply and gas supply valves 3. Disassembly and inspection: Use tools to disassemble the components. It is necessary to check the rotor alignment status and bearing damage 4. Component maintenance: Replace the filter and lubricate, etc.

Atlas Copco 2901110400,Intake control function: The loading and unloading control is achieved through the opening and closing of the intake valve, realizing the loading and unloading control of the air compressor. The operating rule is to load when powered on and unload when power is off. Capacity adjustment: When the storage tank reaches a certain pressure, the intake port is slightly closed under the control of the proportional valve to stabilize the pressure within a certain range. Load reduction startup: When the air compressor starts, the intake valve is in a closed state, reducing the starting load of the compressor and preventing a large amount of gas from entering the machine head. System protection function: Prevent oil spraying. It has the function of preventing oil spraying when unloading or stopping. Ensures the safe operation of the system. Vacuum protection: An intake bypass valve is set on the intake valve to prevent the formation of a high vacuum in the machine head during startup and no-load operation, which may affect the atomization of the lubricating oil. Pressure regulation: The intake volume is adjusted by controlling the length of the piston's extension in the cylinder, and the intake volume of the compressor is controlled.

The air compressor maintenance kit is a set of components designed to facilitate the maintenance and repair of air compressors. It usually includes wear parts, standard parts and specialized tools specific to a certain model or series of air compressors, which can simplify the maintenance process and ensure compatibility of the accessories.

This Chicago Pneumatic air filter element should be changed every 4,000 hours or a minimum of once per year. This filter should be changed on a more frequent basis If your compressor is located in a dirty environment with lots of dust. Changing the air filter will prolong the life of your compressor by protecting the critical parts on the inside of the compressor. Proactively changing the air filter will also increase your energy efficiency by not restricting the inlet airflow going into the air compressor.