China Original 1622486700 Manufacturer, Supplier, Factory

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.

Common Problems and Maintenance Suggestions Oil deterioration: manifested as darker color (turning brown or black), the appearance of sludge, emulsification (becoming milky white). This is mostly caused by high-temperature oxidation, water contamination or pollution. It is necessary to replace the oil immediately and investigate the causes (such as cooling system failure, breathing device blockage). Abnormal increase in fuel consumption: may be due to the failure of the oil separator, clogging of the return oil pipe or damage to the sealing parts. It is necessary to check the relevant components and replace them. Selection Principles: Only Atlas Copco original oil or certified equivalent oil products must be used. Inferior oil will lead to severe carbon deposits, accelerated bearing wear, and even cause major failures such as engine stalling.

1630040899 Atlas Copco operates every 1000-2000 hours or every 6 months. In harsh environments with a lot of dust, the replacement cycle should be shortened. The model is equipped with an air filter clogging indicator. When the indicator alarms, the filter element must be replaced immediately. 1630040899 Atlas Copco. Before installing 1630040899 Atlas Copco, clean the filter housing to ensure a seal and prevent impurities from entering.

Atlas Copco Purchase Recommendation The intake valve assembly and regulator module are the "breathing control center" of the air compressor, and their performance directly affects the energy consumption and stability of the equipment. It is recommended to purchase original factory parts through our authorized dealers of Atlas Copco. The original factory components have undergone strict compatibility tests and can ensure compatibility and long-term reliability with the Z110-145 series models. Non-original factory parts may result in insufficient control accuracy due to size deviations or material issues, and even shorten the equipment lifespan. Regular inspection and timely maintenance of these two components are the key to ensuring the efficient and stable operation of the air compressor.

Original factory parts and selection The model of Atlas Copco fan blades must be strictly matched with the air compressor model (such as GA series, GHS series, etc.). Different models have different dimensions, hole diameters, and blade quantities. Original factory parts can be purchased through our authorized channels to ensure compatibility with the equipment and avoid operational failures caused by size mismatches.

Key Parameters and Replacement Filter Accuracy: Approximately 10 - 15 μm, ensuring the lubricating oil entering the main unit is clean. Replacement Cycle: Usually every 4,000 - 8,000 hours or according to the equipment maintenance manual; apply a small amount of lubricating oil to the sealing ring before installation to avoid dry start-up. Installation Tips: After applying oil to the new filter sealing ring, install it according to the specified torque. After replacement, check the oil level and pressure drop.