China Oil Separator Manufacturer, Supplier, Factory

Atlas Copco Common Problems and Solutions Slip and Abnormal Noise: This is often caused by loose belts, oil contamination, or wear on the pulley grooves. Adjust the tension, clean, or replace the pulley. Excessive Breakage: This may be due to excessive tension, incorrect belt type, misaligned pulley grooves, or excessive load. Check and adjust as necessary. Severe Heating: This is usually caused by slipping or poor heat dissipation. Stop the machine immediately for inspection.

The air compressor oil filter is a key component of the lubrication system of an air compressor. It is mainly used to filter impurities, particles and contaminants in the lubricating oil, ensuring that the lubricating oil entering the compressor meets the cleanliness standards, thereby protecting the internal components of the compressor (such as bearings, gears, rotors, etc.) from wear and damage, and extending the service life of the equipment. Core functions Impurity filtration Intercept solid particles such as metal debris, dust, and carbon deposits, preventing them from circulating into the working components of the compressor. System protection Reduce friction and wear, lower the risk of faults caused by contaminants, and improve the reliability of the compressor. Oil life extension Remove oxidation products and moisture, delay the aging and deterioration of the lubricating oil, and reduce the frequency of oil replacement.

"D70" might refer to the diameter specification of the conveying disc (such as 70mm), which is used to accommodate materials of specific sizes (such as small fasteners, accessories, etc.); "10" might be related to the rated conveying capacity, the applicable pressure parameters (such as 10bar), or the installation interface specifications.

1. loading solenoid valve ‌ : It adopts a two-position three-position normally closed structure and controls the on-off of the pipeline from the oil and gas tank to the intake valve through PLC instructions. When powered on, allow compressed air to enter the intake valve pipeline and open the intake port. When power is cut off, cut off the air passage and expel the residual air in the cylinder, then close the air inlet 2. Vent solenoid valve ‌ : Open the valve for two positions and two normal positions to ensure that the pressure in the oil and gas tank of the air compressor remains at around 0.2MPa when it is no-load. When the machine is shut down and unloaded, cut off the power and release the gas to the intake filter to prevent excessive pressure

Maintenance Tips for the Outer Shell of Atlas Copco Compressor Oil Filter When replacing the oil filter element, check if there are any impurities or oil stains remaining inside the shell. If necessary, clean it to avoid contaminating the new filter element. When installing, ensure that the sealing parts are in good condition and the end cover or sealing cover is firmly tightened to prevent oil leakage. After long-term use, if cracks, deformation or damaged threads are found on the shell, it is necessary to replace it in time to avoid abnormal oil pressure or safety hazards caused by structural failure.

Original Equipment Parts and Replacement Considerations The Atlas Copco gear set is a core component. It is recommended to preferentially use original equipment parts . The advantages of using original equipment parts are as follows: It perfectly matches the parameters of the main unit and the motor, ensuring transmission efficiency The material and processing accuracy meet strict standards, and the lifespan can reach 8-150,000 hours If alternative parts are chosen, the gear module, tooth count, tooth profile , center distance, etc. must be strictly verified to avoid operational failures due to size deviations. In summary, the Atlas Copco air compressor gear set, with its high-precision design and high-quality materials, ensures efficient transmission of the equipment. However, it is necessary to conduct regular maintenance to extend its service life and avoid the entire machine stopping due to gear failures.