China OIL INJECTED SCREW COMPRESSORS Manufacturer, Supplier, Factory

1202626203 Atlas Copco features high-quality filter materials, with excellent filtration accuracy. It can effectively remove tiny particles and oil, meeting the ISO 8573 compression air quality standard. The filter material structure is well-designed, with a high dust-holding capacity, which can reduce the replacement frequency and lower maintenance costs.

1089058022 During the maintenance of the air compressor, Atlas Copco disassembles and cleans the unloaders, removes internal oil deposits and impurities, and checks the wear condition of the valve cores. Replace the worn-out sealing rings, gaskets, etc., to ensure the sealing performance. The multimeter is used to measure the resistance of the coil to determine if it is functioning properly, thus preventing control failure due to electrical faults.

Maintenance and Replacement Recommendations: Regular Cleaning: Check and clean the filter screen weekly to remove impurities. Increase the frequency in high-humidity environments. Seal Replacement: If there is air leakage, replace the aged O-ring or sealing gasket (it is recommended to use original factory parts) first. Overall Replacement: When the valve body is worn out, the valve core is stuck and cannot be repaired, or the electromagnetic valve continues to malfunction, the entire automatic drainage valve assembly needs to be replaced. Original Factory Compatibility: The interface specifications and pressure ratings of the drainage valves for different models of air compressors are different. It is necessary to select Atlas Copco original components to ensure compatibility and safety.

Maintenance precautions for the load reduction device kit of Atlas Copco air compressors: Regularly clean the internal components of the load reducer to prevent the accumulation of oil and impurities, which could cause valve sticking or malfunction. Check the integrity of the seals and replace aging parts in time to avoid pressure control accuracy being affected by leakage. During commissioning, calibrate the pressure setting value according to the equipment manual to ensure accurate loading/unloading switching and avoid frequent start-stop or excessive pressure fluctuations.

Core parameters and replacement Filter accuracy: approximately 10 - 15 μm, protecting the main unit bearings and rotor. Replacement cycle: usually every 4,000 - 8,000 hours or according to the equipment manual; in harsh environments, it can be shortened. Installation tips: After applying oil to the new filter element sealing ring, install it with the specified torque; after replacement, check the oil level and pressure drop.

Maintenance and replacement instructions for the transmission shaft seal kit of Atlas Copco screw air compressors If oil stains or oil leakage are observed near the transmission shaft, or if the consumption of compressor lubricating oil increases abnormally, it may be due to the aging or damage of the seal kit. Therefore, it is necessary to check and replace it in time. When replacing, it is recommended to use the original kit and operate in accordance with the equipment manual to ensure that the seal is installed in the correct direction and tightly attached. In case of necessity, special tools can be used for installation to avoid deformation or damage to the seal.