China Genuine Atlas Copco Part 1621050400 Hose Assembly Manufacturer, Supplier, Factory

If you need to purchase or confirm the specific compatible model, it is recommended to provide the complete model number of the compressor (such as GA22, GA37, etc.), and refer to the corresponding number in the official Atlas Copco spare parts catalogue to ensure complete compatibility of the kit with the equipment. Regular replacement of the original filter kit is an important maintenance measure for maintaining the performance of the compressor and extending its service life.

Atlas Copco Screw Compressor Minimum Pressure Valve Assembly Original Model Selection and Notes It is necessary to select the corresponding specification of the minimum pressure valve assembly according to the compressor model (such as GA75, G110). Original factory parts (such as 1622 series, 0300 series numbers) can ensure that the pressure setting value, flow parameters, and the unit are completely matched. Non-original factory parts may cause unstable performance due to insufficient structural accuracy, and even lead to serious problems such as poor lubrication and failure of oil-gas separation. It is recommended to prioritize the use of original factory components.

Maintenance points for the solenoid valves of Atlas Copco industrial compressors: Solenoid valves are prone to getting stuck or leaking due to impurities and oil contamination in the compressed air or aging of the seals. Regular inspections and cleanings are necessary. If the valve fails to operate properly, it is necessary to check if the power supply is normal and if the valve core is worn. In case of necessity, the original factory solenoid valves should be replaced to avoid control system failures.

Atlas Copco Air Compressor Oil Check Valve Maintenance and Replacement Check Period: It is recommended to conduct checks every 1-2 years or in accordance with the equipment manual (for example, after 4000-8000 hours of operation), and perform the checks simultaneously when replacing the filter and oil. Maintenance Points: Clean the valve core and valve seat to remove impurities; Check the wear of the seals and replace them promptly if they are aged; Test the elasticity of the springs. If the elasticity is insufficient, replace the entire valve. Replacement Precautions: Select original factory parts that match the model (such as Atlas Copco, Ingersoll Rand, etc. have dedicated oil check valves). Ensure that the size and pressure parameters are consistent; Pay attention to the direction during installation, and avoid installing it in the wrong direction; After replacement, start the equipment and check if the oil circuit pressure is normal and if there is any leakage.

1629054716 Atlas Copco FILTER ELEMENT DD/DDP 780-3150+ F is equipped with highly efficient filtering materials, which can effectively trap tiny particles in the air and reduce equipment wear and malfunctions caused by air pollution.

The significance of maintaining the oil filter of Atlas Copco air compressors By strictly following the 2000-hour replacement cycle (or adjusting according to actual working conditions), it is possible to ensure that the oil filter always remains in an efficient filtering state, preventing impurities from entering the main unit and causing wear on the screws and bearings. At the same time, it can reduce the rate of lubricating oil deterioration and extend the service life of the unit. The structural design of the original factory oil filter (such as check valves and bypass valves) can also provide reliable protection during the replacement cycle, and is a fundamental maintenance step for ensuring the long-term stable operation of the air compressor.