China 1621050400 Genuine Hose Assembly Atlas Copco Air Compressors Manufacturer, Supplier, Factory

Model and Purchase Suggestions Full part number: The part number of Atlas Copco's air filters usually consists of multiple digits (such as 1621735200, etc., and C142 might be its specification abbreviation), and the specific number should be based on the equipment manual or the body identification. Purchase Channel: It is recommended to query through Atlas Copco authorized service providers or the official website, providing the complete model of the equipment (such as GA110VSD+) and the factory serial number to ensure the precise compatibility of the accessories. Maintenance Cycle: Follow the recommendations in the VSD + model manual. Generally, it is recommended to replace the filters after 1500-3000 hours (adjust according to the dust concentration in the environment), or replace them promptly when the pressure difference indicator alarms.

For the Atlas Copco 1625599900 820 model hose, when installing it, make sure that the joints at both ends of the hose are securely connected to prevent leakage. During daily use, regularly check if the hose has any signs of aging, cracking, damage, bulging, etc. If any problems are found, replace it immediately to prevent system failures or safety hazards caused by the failure of the hose.

Common Misconceptions and Risks Replacing only the oil but not the filter: Impurities accumulate, accelerating wear and clogging. Overdue use: Increased pressure difference leads to higher energy consumption and an increased risk of filter damage. Installation too tightly: May cause the base to deform or make future disassembly difficult.

Replacement and Maintenance Precautions Cycle Compliance: Follow the specified cycle in the equipment manual for replacement (e.g., air filter every 2000 - 4000 hours, oil-gas separator every 8000 - 12000 hours). In harsh environments (dusty, high temperature), check and replace in advance. Installation Specifications: Release system pressure before replacement and clean the interior of the filter housing. The sealing parts of the new filter need to be coated with clean lubricating oil (for oil filter) or compressed air (for air filter) to ensure a reliable seal. Tighten the end cover or housing with the specified torque to avoid over-tightening which may damage the shell or under-tightening which may lead to leakage. Kit Integrity: The original factory kit includes all necessary components (such as sealing parts, small gaskets), and when replacing, all components must be updated. Do not mix and use old parts.

Correlation check: Verify that the cooler and the lubrication system are unobstructed to prevent premature damage to the temperature control kit due to blockage by other components. After replacement, it is recommended to shorten the initial oil change interval to ensure system cleanliness. The normal operation of the constant temperature kit directly affects the lubrication effect and lifespan of the air compressor. When replacing it, strictly follow the technical manual of the corresponding model.

Atlas Copco Installation and Maintenance Guidelines During installation, it is necessary to clean the oil stains and impurities from the surface of the distance ring, ensuring a tight fit with the mating parts without any gaps or skew. Avoid striking the edge of the distance ring (especially thin-walled parts), as this may cause deformation and affect the dimensional accuracy. During maintenance and inspection, check if the distance ring is worn, deformed or cracked. If any abnormalities are found, it should be replaced promptly; otherwise, it may lead to a decrease in the assembly quality and operational stability of the air compressor, causing vibration, abnormal noise or leakage, etc. Although the distance ring is a small standard part, its accuracy directly affects the assembly quality and operational stability of the air compressor. When selecting and installing, it is necessary to strictly follow the requirements of the equipment manual.