China Atlas Copco Oil-Free Air Compressor Accessory Manufacturer, Supplier, Factory

Atlas Copco Air Compressor "Water Level Sensor" Quick Diagnosis and Common Issues False Alarm / Failure to Report: Check if the installation is loose, if the probe is clogged / blocked or covered; Calibrate or replace the sensor. Continuous Alarm: Check if the drain valve is blocked or if the control logic is abnormal; Clean the valve group and piping. Abnormal after Replacement: Verify the part number, wiring and range / upper and lower limit settings; Reset / re-calibrate if necessary.

The control unit of Atlas Copco's injection-type screw compressors is designed with intelligence, which not only simplifies operation management but also significantly improves the operating efficiency and reliability of the equipment. It is a key guarantee for achieving the "efficient, energy-saving, and safe" operation of the compressors. When choosing, it is necessary to match the corresponding specification of the control unit according to the compressor model and actual working conditions.

ATLAS COPCO 1621049600 Maintenance and Replacement: During regular maintenance of the air compressor, it is necessary to check the condition of the gaskets. If any deformation, aging, or damage is found, they should be replaced immediately; After disassembly, if the gasket has undergone plastic deformation (such as a metal gasket), even if it is not damaged, it is recommended to replace it to avoid repeated use leading to sealing failure; When replacing, it is necessary to use gaskets of the same specification and material as the original ones. It is prohibited to substitute with different types of gaskets (such as using a rubber gasket instead of a metal gasket). Although the air compressor gaskets are small components, they are crucial for the sealing performance of the system. Choosing the appropriate gaskets and correctly installing and maintaining them can effectively reduce leakage faults, reduce energy consumption, and extend the service life of the air compressor.

Daily Maintenance of Air Compressor Intake Valve by Atlas Copco Regular Cleaning: The intake valve is prone to contamination from dust and impurities in the air. It should be disassembled and cleaned regularly to prevent the valve core from getting stuck and affecting normal operation. Check Seals: Aging or damaged sealing components such can lead to air leakage. Regular inspections and timely replacements are necessary. Lubrication Maintenance: For intake valves with moving parts, lubricants should be added according to the instructions to ensure smooth operation. Function Testing: Regularly test the smoothness of the valve's opening and closing and its response time to ensure it can accurately act according to pressure changes. If the intake valve malfunctions, it may cause problems such as insufficient air output, unstable pressure, increased energy consumption, and even affect the lifespan of the entire machine. Therefore, daily maintenance and upkeep are particularly important.

The significance of maintaining the Atlas Copco air compressor temperature control valve kit The precise operation of the temperature control valve can prevent the problem of low oil temperature leading to emulsification of the lubricating oil, poor fluidity (increasing energy consumption), as well as the problem of high oil temperature causing the weakening of the oil film strength and the generation of carbon deposits (accelerating the wear of the main unit). Choosing the original Atlas Copco kit can ensure the compatibility with the oil circuit system of the unit, guarantee the control temperature accuracy and long-term reliability, and is an important maintenance link for maintaining the efficient operation of the air compressor.

"D70" might refer to the diameter specification of the conveying disc (such as 70mm), which is used to accommodate materials of specific sizes (such as small fasteners, accessories, etc.); "10" might be related to the rated conveying capacity, the applicable pressure parameters (such as 10bar), or the installation interface specifications.