China atlas copco G2 Manufacturer, Supplier, Factory

Atlas Copco Air Compressor Lubricants (also known as air compressor oils) precautions For screw-type air compressors, only the dedicated screw oil (which cannot be used interchangeably with piston oil) should be used. Although oil-free air compressors do not come into contact with compressed air, the bearings and other parts still require lubrication (using dedicated lubricating grease). It is recommended to choose the original factory lubricants (Atlas Copco) recommended by the equipment manufacturer to ensure compatibility and performance matching. Correct selection and maintenance of lubricants can significantly reduce the failure rate of air compressors, extend equipment lifespan, and at the same time reduce energy consumption and maintenance costs.

Common Faults and Solutions of Atlas Copco Air Compressor Pressure Gauges Pointer not moving or stuck Reason: Internal gears stuck, spring tube damaged, interface blocked (impurities or condensate water frozen). Solution: Disassemble and clean, remove the blockage; replace the gauge if severely damaged. Incorrect or drifting reading Reason: Elastic element fatigue (long-term use), pointer loose, drastic changes in environmental temperature. Solution: Re-calibrate; replace aging components or pressure gauge. Shell leakage Reason: Sealing of shock-resistant gauge is poor, screws of the shell are loose. Solution: Add silicone oil / glycerin and seal; tighten the screws; replace the shell if severely damaged.

Strict model matching: Different series of Atlas Copco air compressors (such as fixed type, mobile type, screw type, etc.) may require different specifications of coolant. Please select the corresponding original factory coolant based on the specific model of the equipment (such as GA75, XAS186, etc.). For example, some models use long-lasting coolant, with a replacement cycle of up to 8,000 - 10,000 hours. It is not allowed to mix this coolant with other brands or types of coolant at will.

Atlas Copco 1631090801 Pipe G 1/4X245, G1/4 interface size, G represents imperial non-threaded sealed pipe thread, the thread size is 1/4 inch, 245 represents the pipe length.

Atlas Copco Air compressor HOURMETER The speedometer is the "barometer" of the operating condition of the air compressor. By monitoring the changes in its values, potential problems of the equipment can be detected in a timely manner, ensuring the efficient and stable operation of the unit. During daily operations, it is recommended to comprehensively analyze the equipment status by combining the other parameters displayed by the control unit (such as pressure, temperature, and current).

Maintenance Points Regularly replace the filter element: Based on the usage environment and operating time (generally recommended every 2,000-4,000 hours) , replace the filter element to avoid increased pressure loss and reduced filtering effect due to blockage. Pressure difference monitoring: Some models are equipped with a pressure difference indicator. When the filter element becomes clogged to a certain extent, it will give a prompt, and it is necessary to replace it in time to ensure the normal operation of the system. Sealing check: Regularly check the interface sealing condition of the filtering component to prevent unfiltered compressed air from leaking into the downstream system. If you need to purchase filter elements or want to know about specific compatible models, it is recommended to refer to the PD295 filtering component technical document provided by Atlas Copco officially, or provide the detailed model of the air compressor (such as GA37, GA55)