China Atlas Copco 1616580381 Manufacturer, Supplier, Factory

Replacement and Maintenance Suggestions: When the shaft sleeve shows excessive wear, scratches, cracks, or if the fit with the shaft exceeds the limit, it should be replaced immediately; otherwise, it may cause wear on the shaft neck, increased vibration, or abnormal noise from the equipment. When replacing, use original factory parts and ensure that the surface of the shaft and the bearing housing are cleaned before installation. If necessary, perform size checks according to the manual requirements. During installation, avoid knocking the shaft sleeve to cause deformation. If necessary, use professional techniques such as hot assembly to ensure the fit accuracy.

ATLAS COPCO Air Compressor "Purification Tube Assembly" Replacement and Maintenance Recommendations Replacement Cycle: At least once a year; Replace when pressure drop exceeds preset value or indicator indicates; In some operating conditions, this can be shortened to 4,000 hours or less. Operation Points: Replace the entire unit or isolate and depressurize the part before replacement; Check the double O-rings and other seals during replacement; Do not clean the filter element; Only replace the original factory parts. Energy Savings Benefits: High-quality filter elements can reduce pressure drop and lower energy consumption; Ignoring the replacement will lead to a significant increase in energy consumption.

Based on the general accessory information for this series of models, the relevant reference number for the vent hole kit of ZT15-22 may be: Some models use a ventilation assembly with the serial number 2901111500 (including ventilation plugs, sealing rings, etc.);

1. Daily maintenance and cleaning Daily drainage: The compressor will produce moisture during operation. To avoid pipeline blockage, we recommend draining the moisture once a day to ensure smooth system flow.

Atlas Copco 2903775400=1625775400 Notes for Attention Choosing the original factory oil filter (such as the products corresponding to these two numbers) can ensure that the filtration efficiency, size accuracy and equipment are fully matched, avoiding the risk of host wear caused by the failure of inferior filter elements. If there is a replacement relationship between the numbers, when replacing, you can directly use the new number parts, and their performance and compatibility are the same as the old numbers.

Atlas Copco Air Compressor Pressure Valve Cover Plate Daily Maintenance: Regularly inspect the cover plate for any looseness, deformation or cracks. If the bolts are loose, they must be tightened promptly. If there are cracks, the cover plate must be replaced. Check for any air leakage traces at the joint. If there is leakage, disassemble and inspect the seals to see if they are aged or damaged. In necessary cases, replace the seals and reinstall them. When maintaining the internal components of the pressure valve , be careful when removing the cover plate to avoid excessive force causing the cover plate to deform or the bolts to slip. Although the pressure valve cover plate is a structural component, its sealing performance and pressure-bearing capacity directly affect the control accuracy and system safety of the pressure valve. During installation, ensure reliable sealing.