China 1616580381 Manufacturer, Supplier, Factory

The impact of filter oil system failure in Atlas Copco air compressors If the filter elements fail or are not maintained properly, it may lead to: Excessive oil content in compressed air, contaminating downstream equipment or products (especially having a significant impact on industries such as food and medicine). Increased impurities in lubricating oil, accelerating wear of components such as rotors and bearings, and shortening the equipment's lifespan. Excessive differential pressure in the oil-gas separator, increasing energy consumption and even causing the system to overload and shut down.

New jet screw, oil-free screw, centrifugal compressor, ROTZ, screw, centrifugal blower; After treatment dryer, cooling dryer, filter; Pressure swing adsorption nitrogen machine; In addition, controller expansion has been optimized, and energy recovery equipment and over 20 new products will be provided simultaneously.

Atlas Copco Air Compressors Oil Injected Screw Compressor Ball Valve 1/4 Selection Recommendation Applicable Models: The interface standards and working parameters need to be confirmed based on the specific model of the oil-injected screw compressor (such as Atlas Copco GA series small machines, Ingersoll Rand SSR series, etc.). Certification Requirements: Prioritize products that comply with industrial standards (such as ISO, DIN) to ensure compatibility with the system. Maintainability: Choose a disassemblable and repairable structure to facilitate the replacement of seals and extend the service life. If used to replace original factory parts, it is recommended to provide the compressor model and the original valve part number to ensure complete matching of size and pressure rating, avoiding any impact on system operation due to compatibility issues.

Strict model matching: Different series of Atlas Copco air compressors (such as fixed type, mobile type, screw type, etc.) may require different specifications of coolant. Please select the corresponding original factory coolant based on the specific model of the equipment (such as GA75, XAS186, etc.). For example, some models use long-lasting coolant, with a replacement cycle of up to 8,000 - 10,000 hours. It is not allowed to mix this coolant with other brands or types of coolant at will.

Replacement and selection suggestions for flat washers of Atlas Copco air compressors When replacing, it is necessary to strictly match the original specifications to avoid sealing failure or connection loosening due to size mismatch. For high-pressure, high-temperature or areas in contact with compressor oil, it is recommended to use original factory metal flat washers to ensure that the material is oil-resistant and pressure-resistant. If it is a critical sealing part (such as the end cover of the oil-gas separator), check whether the surface of the washer is flat, without scratches or deformation. If necessary, replace the new part to ensure the seal. For specific models or part numbers, you can refer to the parts manual of the air compressor (usually identified by a numerical code, such as 0650 series, 1622 series), or consult the Atlas Copco after-sales service for the equipment model to obtain precisely matched parts.

Attention points for replacing the drive components and connecting parts of Atlas Copco GA15VSD screw air compressor When replacing parts such as belts and couplings, original factory parts (such as belt model and coupler specification must match the equipment) should be used. Non-original factory parts may cause transmission abnormalities due to size deviations. During installation, the coaxiality between the motor and the main unit must be ensured (belt transmission allows a small deviation, while coupler transmission requires strict calibration). Otherwise, it will lead to premature wear of bearings and increased vibration. After replacement, a trial run is required to monitor vibration, noise and temperature, and confirm that the drive system is operating normally.