China Air Compressor Drive Belt Manufacturer, Supplier, Factory

Maintenance and replacement instructions for the transmission shaft seal kit of Atlas Copco screw air compressors If oil stains or oil leakage are observed near the transmission shaft, or if the consumption of compressor lubricating oil increases abnormally, it may be due to the aging or damage of the seal kit. Therefore, it is necessary to check and replace it in time. When replacing, it is recommended to use the original kit and operate in accordance with the equipment manual to ensure that the seal is installed in the correct direction and tightly attached. In case of necessity, special tools can be used for installation to avoid deformation or damage to the seal.

The maintenance significance of the check valve stem adjustment kit for Atlas Copco ZT55-90 series air compressors Precise valve stem adjustment can ensure that the intake valve fully opens when loaded (reducing intake resistance) and fully closes when unloaded (preventing compressed air from flowing back), directly affecting the volumetric efficiency and energy consumption of the compressor. Regular inspections can help detect valve stem wear or jamming issues in advance, avoiding unit shutdown or overload damage to core components (such as the main unit and motor) due to failure of the intake valve. When choosing, it is recommended to prioritize the use of Atlas Copco original kit to ensure that the component size, material, and model fully match the ZT55-90 series, guaranteeing the adjustment effect and equipment operation reliability.

The CHECK VALVE with the number 2236043880 plays a crucial role in preventing the backflow of compressed air in oil-free air compressors. It ensures that the compressed air flows in the prescribed direction, guaranteeing the normal operation of the air compressor and the quality of the compressed air. The Atlas Copco SF and SF + series oil-free vortex air compressors are equipped with enlarged vertical check valves, which further enhance the reliability during the service life and ensure that customers always receive high-quality compressed air.

Maintenance and Replacement Precautions for the Bushings of Atlas Copco Air Compressors Original Factory Parts Preferred: It is recommended to use Atlas Copco's original bushings to ensure dimensional accuracy and material compatibility, avoiding secondary damage caused by sub-brand parts quality issues. Installation Precision: The replacement should be carried out by professional technicians. The interference fit between the bushing and the bearing housing, as well as the clearance between the bushing and the shaft neck, must be strictly controlled. Special tools may be used for press-fitting in necessary cases. Compliance Check: After installation, the rotor clearance should be detected using a feeler gauge or precise instruments to ensure it meets the technical standards. Lubrication Assurance: After replacement, the specific compressor oil should be added in accordance with the specifications. Before starting, ensure that the lubrication system is properly supplied with oil.

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.

Product Overview: LZB34-RL-A013-11 is a high-performance stainless steel series pneumatic motor. It is made of stainless steel and features excellent corrosion resistance and durability, making it suitable for environments with strict hygiene requirements, such as food processing and chemical industries. Its lubrication-free design ensures cleanliness during operation, while it also boasts a high power-to-weight ratio and a wide speed range, enabling it to meet the needs of various industrial applications.