China Compressor Drive Belt Manufacturer, Supplier, Factory

Basic working principle A three-phase induction motor generates a rotating magnetic field by connecting to three-phase alternating current and passing it through the stator windings. The rotor cuts the magnetic lines of force in the magnetic field, generating an induced current, which is then subjected to electromagnetic force and rotates in accordance with the magnetic field (the rotational speed is slightly lower than that of the rotating magnetic field, and there is a slip rate). The electrical energy is converted into mechanical energy to drive the compression mechanism of the air compressor (such as pistons, screws, etc.) to operate. Adaptation features

Atlas Copco 2205177596 is designed for different equipment series. It features both elastic coupler and rigid coupler types, using high-strength material elastic rubber. This product is suitable for the high-load and continuous operation requirements of industrial environments.

Atlas Copco Installation and Maintenance Tips Installation Requirements: The metal sealing surfaces must be thoroughly cleaned (free of oil stains and scratches), and the fastening bolts must be tightened uniformly to the specified torque (usually 30-50 N·m) to ensure that the sealing elements are fully in contact. Cleaning Cycle: Depending on the operating environment, the metal filter element should be back-flushed for cleaning every 2000-4000 hours (using dry compressed air to blow from the inner side of the filter element outward). An ultrasonic deep cleaning should be performed after a cumulative operation of 10000 hours. Replacement Criteria: When there is local damage to the filter element (detected through an endoscope) or permanent deformation of the sealing element surface (resulting in an excessive leakage rate), the corresponding components should be replaced promptly.

Maintenance and Replacement Recommendations: Regular Cleaning: Check and clean the filter screen weekly to remove impurities. Increase the frequency in high-humidity environments. Seal Replacement: If there is air leakage, replace the aged O-ring or sealing gasket (it is recommended to use original factory parts) first. Overall Replacement: When the valve body is worn out, the valve core is stuck and cannot be repaired, or the electromagnetic valve continues to malfunction, the entire automatic drainage valve assembly needs to be replaced. Original Factory Compatibility: The interface specifications and pressure ratings of the drainage valves for different models of air compressors are different. It is necessary to select Atlas Copco original components to ensure compatibility and safety.

Compatibility and Procurement The specifications of the gear hydraulic pumps equipped on different models of Atlas Copco industrial compressors (such as large fixed compressors, mobile compressors, etc.) vary. Specific parameters should be referred to in the hydraulic system description section of the equipment manual. If you need to purchase or replace, it is recommended to contact Atlas Copco's official website. Provide the compressor model and pump nameplate information (such as model, serial number) to ensure the precise compatibility of the accessories.

Recommendation for the Atlas Copco Preventive Maintenance Kit B Model Matching: Make sure to select the corresponding Kit B based on the specific series, model, and serial number of the air compressor. The component specifications vary for different models, and incorrect matching may affect the maintenance effect; Replacement Timing: Follow the maintenance cycle recommended by Atlas Copco's official manual. This is usually related to the operating hours of the equipment and the working conditions; Professional Operation: It is recommended to have the replacement carried out by authorized service personnel from the original factory or professional technicians who have received training. Ensure the installation is in accordance with the specifications, and after the replacement, system debugging and performance testing are required.