China 2204155654 Atlas Copco Manufacturer, Supplier, Factory

The WSD250-750, as the original drainage component, has the best compatibility with Atlas Copco air compressors and post-treatment equipment. It can effectively prevent leakage or poor drainage problems caused by the mismatch of accessory part sizes.

Atlas Copco Air Compressor "Water Level Sensor" Quick Diagnosis and Common Issues False Alarm / Failure to Report: Check if the installation is loose, if the probe is clogged / blocked or covered; Calibrate or replace the sensor. Continuous Alarm: Check if the drain valve is blocked or if the control logic is abnormal; Clean the valve group and piping. Abnormal after Replacement: Verify the part number, wiring and range / upper and lower limit settings; Reset / re-calibrate if necessary.

Common Problems and Solutions for Atlas Copco Air Compressor Air Filter Enclosures Increased intake resistance: This may be due to foreign objects blocking the interior or an unreasonable design of the airflow channel. Clean the debris or replace the compatible enclosure. Sealing failure: This is often caused by aging seals or deformed enclosures. Replace the sealing ring or repair the enclosure (metal enclosures can be corrected, while plastic enclosures are recommended to be replaced directly). Enclosure damage: Minor damage to the metal enclosure can be repaired by welding. Severe deformation or cracking of the plastic enclosure requires a complete replacement to avoid affecting the filtration effect. Selecting an appropriate air filter enclosure and using high-quality filter elements can effectively ensure the long-term stable operation of the air intake system of the air compressor, reducing the wear of the main unit and energy loss.

Atlas Copco Air Compressor Pressure Valve Cover Plate Daily Maintenance: Regularly inspect the cover plate for any looseness, deformation or cracks. If the bolts are loose, they must be tightened promptly. If there are cracks, the cover plate must be replaced. Check for any air leakage traces at the joint. If there is leakage, disassemble and inspect the seals to see if they are aged or damaged. In necessary cases, replace the seals and reinstall them. When maintaining the internal components of the pressure valve , be careful when removing the cover plate to avoid excessive force causing the cover plate to deform or the bolts to slip. Although the pressure valve cover plate is a structural component, its sealing performance and pressure-bearing capacity directly affect the control accuracy and system safety of the pressure valve. During installation, ensure reliable sealing.

The centrifugal cooling fan feature of Atlas Copco air compressor GA55: It adopts a low-speed centrifugal fan design, featuring high cooling air volume and low noise. The fan energy-saving cycle controls the fan's start/stop by monitoring the outlet temperature of the main unit and the ambient temperature. This not only saves energy but also prevents condensation water from forming in the GA VSD compressor when operating at low loads.PRICE INQUIRY

Atlas Copco Gear Trial Run and Inspection Preliminary Inspection Manually rotate the gear shaft to feel if the rotation is smooth, and check for any sticking, abnormal noise or eccentric vibration. Check if the lubrication path in the gearbox is unobstructed, and add gear oil to the standard level as per the regulations. No-load Trial Run Connect the power supply and conduct a short-term (5-10 minutes) no-load operation. Listen for any abnormal noises (such as metal friction sounds, high-frequency squeals) from the gearbox. After stopping the machine, check the temperatures of the bearings and gears (should not exceed the ambient temperature by 40°C), and observe for any oil leakage. Load Test Gradually load to the rated pressure and run for more than 30 minutes. Recheck the noise, temperature and sealing conditions, and confirm there are no abnormalities.