China 1617617300 Atlas Copco Manufacturer, Supplier, Factory

Never forget to order a spare part and avoid unplanned downtime. As your original equipment manufacturer, we know exactly which parts are needed for every service intervention. These are offered as a single maintenance kit with the quality assurance of genuine Atlas Copco parts.

Fault and Replacement Suggestions: If the fuel injection valve becomes clogged, stuck, or leaks, it may cause the following issues: Insufficient fuel injection: Poor lubrication of the main engine, increased temperature, leading to rotor wear or abnormal noise; Excessive fuel injection: Increased oil content in the compressed air, heavier load on the oil separator, and increased energy consumption; Uneven fuel injection: Insufficient lubrication in some parts of the rotor, resulting in uneven wear or overheating. Suggestions: During daily maintenance, check if there is any oil accumulation on the fuel injection valve and clean the filter regularly (if applicable); When encountering abnormal engine temperature, increased fuel consumption, or abnormal noise, promptly inspect the condition of the fuel injection valve;

Atlas Copco Air Compressor Pressure Valve Cover Plate Daily Maintenance: Regularly inspect the cover plate for any looseness, deformation or cracks. If the bolts are loose, they must be tightened promptly. If there are cracks, the cover plate must be replaced. Check for any air leakage traces at the joint. If there is leakage, disassemble and inspect the seals to see if they are aged or damaged. In necessary cases, replace the seals and reinstall them. When maintaining the internal components of the pressure valve , be careful when removing the cover plate to avoid excessive force causing the cover plate to deform or the bolts to slip. Although the pressure valve cover plate is a structural component, its sealing performance and pressure-bearing capacity directly affect the control accuracy and system safety of the pressure valve. During installation, ensure reliable sealing.

Maintenance suggestions for the regulating valves of Atlas Copco air compressors: Regularly clean the interior of the valves to remove oil stains and impurities (especially the intake regulating valve which is prone to dust influence). Replace the seals and wear parts (such as diaphragms, springs) according to the manual schedule. Calibrate the pressure setting values to ensure they match the system requirements. In case of faults, prioritize replacing the original factory-regulated valves (such as Atlas Copco-specific parts) to avoid system instability due to size or performance mismatch.

Attention points for pressure reducers in Atlas Copco air compressor systems: Matching system pressure: The rated input pressure of the pressure reducer must match the exhaust pressure of the air compressor (for example, if the rated pressure of the air compressor is 10 bar, a pressure reducer with a rated input of ≥ 10 bar should be selected). Downstream load limit: The output pressure should be set according to the rated working pressure of the downstream equipment to avoid overpressure damage to the equipment. Regular calibration: After long-term use, pressure drift may occur, so it is necessary to regularly check and calibrate to ensure stable pressure.

Atlas Copco Air Compressor Oil Separation Filter Purchase Recommendation To ensure the separation effect and equipment safety, it is recommended to purchase the original factory oil separation cores through our authorized dealers. Using inferior substitute filters may result in insufficient separation efficiency, short lifespan, and even damage to the main unit, thereby increasing maintenance costs. The performance of the oil separation filter directly affects the operating efficiency, energy consumption, and downstream gas quality of the air compressor. It is a component that needs to be focused on during maintenance.