China 1420070853 Manufacturer, Supplier, Factory

The Atlas Copco air compressor oil level indicator, although having a simple structure, is of vital importance for the safe operation of the equipment. During daily inspections, special attention should be paid to whether the oil level is normal and whether the oil quality has deteriorated. This ensures that the lubricating, cooling and sealing functions of the lubricating oil are fully exerted, thereby extending the service life of the air compressor.

ATLAS COPCO PT1000 Operating Instructions Operators should be familiar with the meanings of fault codes (refer to the equipment manual) to quickly identify and solve problems. The adjustment of key parameters such as pressure should be within the rated range of the equipment to avoid overpressure operation and potential safety risks. Regularly check the connection lines of the controller to prevent signal transmission interference caused by vibration and oil contamination.

Atlas Copco EWD330 Electronic Drain Valve Maintenance Recommendations Compatible Models: This product is only applicable to Atlas Copco EWD330 electronic drain valves. Before purchase, confirm the production batch and electromagnetic valve specifications of the drain valve to avoid model mismatch. Maintenance Timing: When the drain valve shows slow operation, abnormal drainage (such as no drainage or continuous drainage), abnormal noise from the electromagnetic valve, or air leakage, it may be necessary to repair the electromagnetic valve. At this time, this kit can be used to replace the worn parts. Installation Notes: It is recommended to operate by professionals. Before maintenance, cut off the power and gas sources, assemble in accordance with the original factory manual specifications, ensure that the components are installed properly, and avoid functional failures or safety hazards due to improper assembly.

The working principle of the constant temperature valve for Atlas Copco air compressors: When the air compressor starts, the oil temperature is low. The constant temperature valve will close the oil circuit of the cooler, allowing the lubricating fluid to directly enter the main unit, rapidly increasing the temperature and reducing wear. When the temperature rises to 70-80 degrees Celsius, the constant temperature valve will slowly open the cooling channel of the cooler, allowing the lubricating oil to cool down before entering the circulation. This can prevent the oil temperature from being too high, which would lead to a decrease in lubrication effect and overheating problems of the equipment.

Atlas Copco Installation and Maintenance Tips Installation Requirements: The metal sealing surfaces must be thoroughly cleaned (free of oil stains and scratches), and the fastening bolts must be tightened uniformly to the specified torque (usually 30-50 N·m) to ensure that the sealing elements are fully in contact. Cleaning Cycle: Depending on the operating environment, the metal filter element should be back-flushed for cleaning every 2000-4000 hours (using dry compressed air to blow from the inner side of the filter element outward). An ultrasonic deep cleaning should be performed after a cumulative operation of 10000 hours. Replacement Criteria: When there is local damage to the filter element (detected through an endoscope) or permanent deformation of the sealing element surface (resulting in an excessive leakage rate), the corresponding components should be replaced promptly.

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.