China Atlas Copco air compressor spare parts Manufacturer, Supplier, Factory

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.

As an air compressor manufacturer, we often receive inquiries from customers. The company wants to purchase a batch of air compressors but doesn’t know how to choose or how to make reference. Here we summarize for you how to choose a suitable air compressor in general.

2901056800 Atlas Copco Advantage: No need to move the compressor. Maintenance work can be carried out directly from the front end of the equipment, saving space and labor costs. At the same time, the standardized kit configuration can avoid delays during maintenance due to mismatch of tools and spare parts, which is particularly suitable for scenarios in industrial production where continuous operation of equipment is required.

Key points for replacement and maintenance: When replacing, the oil separator filter element should be replaced simultaneously. Also, check if the sealing gasket is aged. If necessary, replace it together to ensure a proper seal. Before installation, clean the oil stains and impurities on the interface surface. Tighten according to the specified torque to avoid over-tightening which may cause the shell to deform or under-tightening which may lead to leakage. Regularly (usually in accordance with the filter element replacement cycle, approximately 2000-4000 hours) check if there are any cracks, corrosion or deformation in the shell. Replace it promptly if any abnormalities are found.

Due to the wide range of Atlas Copco compressor models (such as GA, GAe, GHS, etc.), there are differences in the electrical component specifications for different models. When purchasing or replacing components, it is necessary to provide the specific model, serial number, and component number of the compressor to ensure compatibility with the electrical system of the equipment. It is recommended to obtain accurate component information and compatibility suggestions from our authorized dealers.

Function: Filtering impurities: During the operation of the air compressor, the lubricating oil will generate metal debris due to friction with metal components, and the oil itself will also produce gums and other impurities due to heating and oxidation with air. The oil filter can effectively remove these impurities, such as metal particles and deteriorated oil substances. The filtration accuracy is usually between 5-15 μm, maintaining the cleanliness of the oil passage, preventing impurities from entering critical components such as bearings, gears, and main body cavities, reducing wear and extending the service life of the equipment. Ensuring lubrication effect: Ensure that the oil entering the main unit is pure, maintain good lubrication performance, allow the friction surfaces to be fully lubricated, reduce friction loss, and avoid faults caused by poor lubrication due to impurities, such as bearing damage, rotor seizing, etc.