China teslimat DISK D70/10 sineklik Manufacturer, Supplier, Factory

The GA series compressors offer an ideal solution for modern industrial applications. These compressors, equipped with advanced technology, can optimize the air compression process and reduce energy consumption. This not only helps to lower the operational costs of enterprises but is also an environmentally friendly approach. The GA series compressors have the ability to adapt to different air demands, which is highly regarded. These compressors adopt a modular design and can easily meet the expansion needs of factories. In addition, their design aims to minimize the maintenance requirements of users. With the aid of automatic control systems and remote monitoring options, maintenance work is simplified, ensuring that operations can proceed smoothly without interruption.

Maintenance recommendations for the oil filter of Atlas Copco screw air compressors: Replacement cycle: Under normal operating conditions, replace the filter once every 2,000 - 3,000 hours. In harsh environments (such as high dust and high temperature), this period should be shortened to 1,500 hours. Synchronous operation: When replacing the filter element, also simultaneously discharge the settled oil at the bottom of the oil tank (containing a large amount of impurities) and refill the oil to the specified level. Selection requirements: It is necessary to select original factory or certified filter elements that match the compressor model to avoid equipment damage due to size mismatch or insufficient filtration accuracy. Effective maintenance of the oil filter can significantly reduce the wear rate of the screw main unit and is a key aspect of the daily maintenance of the compressor unit with low cost and high efficiency.

Attention points for replacing the drive components and connecting parts of Atlas Copco GA15VSD screw air compressor When replacing parts such as belts and couplings, original factory parts (such as belt model and coupler specification must match the equipment) should be used. Non-original factory parts may cause transmission abnormalities due to size deviations. During installation, the coaxiality between the motor and the main unit must be ensured (belt transmission allows a small deviation, while coupler transmission requires strict calibration). Otherwise, it will lead to premature wear of bearings and increased vibration. After replacement, a trial run is required to monitor vibration, noise and temperature, and confirm that the drive system is operating normally.

Procurement and adaptation confirmation of Atlas Copco air compressor spare parts 1635316600: It is recommended that we purchase the original spare parts through Atlas Copco to ensure that the size and filtering accuracy match the equipment. If you need to confirm whether it is compatible with your air compressor, please provide the complete model and serial number of the equipment and contact us for further verification.

The original Atlas Copco air filter maintenance kit has been rigorously tested in terms of filtration efficiency, dust holding capacity, and structural strength, and is perfectly matched with the equipment design. It can maximize the filtration effect. Non-original filter elements may have issues such as insufficient filtration accuracy, excessive intake resistance, or poor sealing. Long-term use may lead to accelerated wear of the main unit, increased energy consumption, and ultimately increase the maintenance cost of the equipment.

Replacement and Maintenance Recommendations: Replacement Cycle: Generally, replace once every 3,000 - 4,000 hours or annually (whichever comes first). In harsh environments, the cycle should be shortened; Replacement Indicators: If the oil content in the compressed air exceeds the standard (oil stains appear at the air inlet), or if the pressure difference between the separator inlet and outlet is too high (more than 0.8 - 1.0 bar), replace immediately; Installation Notes: During replacement, clean the interface, check the integrity of the sealing ring, and tighten according to the specified torque; after replacement, discharge the air inside the tank to ensure the system operates normally.