China Original Atlas Copco Air Compressor Gear Set Manufacturer, Supplier, Factory

Atlas Copco Daily Maintenance: Manual Drain Valve: Drain at least 1-2 times per day. The drainage effect is better after the machine is shut down (at this time, the system pressure is low and water is easier to be discharged). Automatic Drain Valve: Check once a week. Clean the impurities (such as oil stains, rust) in the filter or float ball to prevent blockage. Electronic Drain Valve: Regularly check if the timer settings are reasonable, clean the electromagnetic valve valve core to ensure smooth operation. When the ambient temperature is below 0℃, take measures such as insulation or heating to prevent the drainage port from freezing and getting clogged.

Maintenance and Replacement Precautions for Atlas Copco Air Compressor Oil Check Valve Kit Regularly inspect the sealing performance and operational flexibility of the check valve to prevent failure of the check valve or increased resistance in the oil circuit due to valve core jamming or wear of the sealing components. When replacing, use the original factory kit to ensure compatibility with the oil circuit parameters of the model , to avoid affecting the lubrication effect due to incompatible specifications. Before installation, clean the oil circuit interface to remove impurities; after installation, check the oil circuit pressure through trial operation to confirm there is no leakage before putting it into use. It is recommended to replace with lubricating oil, oil filters, etc. at the same time to ensure the cleanliness and performance consistency of the entire oil circuit system.

Suggestions on the use and purchase of Atlas Copco air compressor air compressor pressure valve maintenance kit: It is recommended that professional technicians replace according to the equipment maintenance manual to ensure correct assembly accuracy and pressure parameter settings. This kit is an original accessory with the serial number 2901099700, which can be used as a precise procurement identifier. If you need to confirm whether it is compatible with your compressor, you can provide us with the complete model and serial number of the equipment for consultation Regularly replacing maintenance kits (such as based on operating hours or maintenance cycles) can extend the service life of pressure valves and ensure efficient operation of compressors.

Atlas Copco Air Compressor Intake Valve Maintenance Kit Compatibility and Selection The intake valve structures of different series of air compressors (such as GA37, GA75, ZT55, etc.) are different. The maintenance kit needs to be strictly matched with the model of the air compressor. Usually, the model of the air compressor or the part number of the intake valve is used as the selection basis (such as the 1622 series intake valve maintenance kit for the GA series). It is recommended to select the corresponding kit based on the specific model of the air compressor, the production year, and the model of the intake valve (you can query it in the equipment manual or on the valve body label). Avoid mismatch in size or components.

Selection and precautions for the oil-water separator of Atlas Copco G series air compressors The oil-water separator should be selected based on the specific model (such as G37, G75) and displacement of the G series air compressor to ensure that the processing capacity matches. It is recommended to use the original Atlas Copco oil-water separator and filter element. Their materials (such as the filter element using high-efficiency fiberglass or polyester materials) and structural design are fully compatible with the G series models, which can ensure separation efficiency and service life, and avoid secondary pollution or excessive pressure loss caused by compatibility issues.

Atlas Copco Installation and Maintenance Tips Installation Requirements: The metal sealing surfaces must be thoroughly cleaned (free of oil stains and scratches), and the fastening bolts must be tightened uniformly to the specified torque (usually 30-50 N·m) to ensure that the sealing elements are fully in contact. Cleaning Cycle: Depending on the operating environment, the metal filter element should be back-flushed for cleaning every 2000-4000 hours (using dry compressed air to blow from the inner side of the filter element outward). An ultrasonic deep cleaning should be performed after a cumulative operation of 10000 hours. Replacement Criteria: When there is local damage to the filter element (detected through an endoscope) or permanent deformation of the sealing element surface (resulting in an excessive leakage rate), the corresponding components should be replaced promptly.