China Atlas Copco Air Dryer Manufacturer, Supplier, Factory

Faults and Replacement Suggestions: Common Faults and Handling: Winding Burnout: Usually caused by abnormal voltage or long-term overloading, manifested as the electromagnetic valve not moving. It is recommended to replace the entire electromagnetic valve (including the winding); Valve Core Stuck: Caused by impurities or oil contamination, preventing the valve from fully opening or closing, which may lead to abnormal pressure or poor drainage. It is necessary to replace the original part; Leakage: Caused by aging of the sealing components, it is necessary to replace in time to avoid loss of compressed air or engine oil. When replacing, please note: Power off operation, confirm that the voltage specification is consistent, and when installing, the sealing component should be coated with a small amount of engine oil to enhance the sealing performance.

Recommendations for Atlas Copco Air Compressor Oil Filter Selection It is essential to use the original Atlas Copco oil filter. The filter material, structural strength, and sealing performance have undergone rigorous testing and are fully compatible with the lubrication system of the unit. Third-party oil filters may have issues such as insufficient filtration accuracy, mismatched bypass valve parameters, or poor oil resistance of the sealing ring, which can lead to accelerated machine wear, lubricant leakage, or abnormal system pressure, increasing the risk of equipment failure.

The electromagnetic valve maintenance kit for Atlas Copco EWD330 electronic drainage valve is applicable for maintenance suggestions. Applicable models: Only applicable to Atlas Copco EWD330 type electronic drainage valve. Before purchase, it is necessary to confirm the production batch and electromagnetic valve specification of the drainage valve to avoid model mismatch. Maintenance timing: When the drainage valve shows slow operation, abnormal drainage , abnormal noise from the electromagnetic valve, or air leakage, it may be necessary to repair the electromagnetic valve. At this time, this kit can be used to replace the worn parts. Installation note: It is recommended to operate by professionals. Before maintenance, cut off the power and air source, assemble in accordance with the original factory manual specifications, ensure that the components are installed properly, and avoid functional failure or safety hazards due to improper assembly.

Choosing the Atlas Copco 8000 hour service package is an important measure to ensure the long-term and efficient operation of the compressor. It is particularly suitable for industries that require continuous production (such as manufacturing and energy industries), and through regular maintenance, it can minimize the overall maintenance cost of the equipment.

Suggestions on the use and purchase of Atlas Copco air compressor air compressor pressure valve maintenance kit: It is recommended that professional technicians replace according to the equipment maintenance manual to ensure correct assembly accuracy and pressure parameter settings. This kit is an original accessory with the serial number 2901099700, which can be used as a precise procurement identifier. If you need to confirm whether it is compatible with your compressor, you can provide us with the complete model and serial number of the equipment for consultation Regularly replacing maintenance kits (such as based on operating hours or maintenance cycles) can extend the service life of pressure valves and ensure efficient operation of compressors.

Maintenance and servicing tips for the tubular coolers of Atlas Copco compressors: Regular cleaning: Depending on the operating environment, clean the inside and outside of the cooling tubes of the tubes and the sealing surfaces of the caps (using chemical cleaning or mechanical flushing) to prevent a decline in heat exchange efficiency. Leak detection: Check for any leaks at the pipe connections and sealing surfaces of the caps. Replace the seals or repair damaged pipes in a timely manner. Flow monitoring: Ensure that the flow and pressure of the cooling medium (water or air) are within the specified range. If insufficient, investigate pipe blockages or pump/fan failures. Anti-freezing protection： In low-temperature environments， after shutdown， drain the accumulated water in the cooling water pipes to prevent cracking due to freezing.