China atlas copco air compressor oil Manufacturer, Supplier, Factory

Atlas Copco 2906014600,Reducing gas temperature in multi-stage compression process, after the gas passes through the previous stage of compression, its temperature will rise sharply. The intercooler is located between the compression stages and can cool the high-temperature gas, providing lower-temperature and denser gas for the next stage of compression. Enhancing system efficiency The cooling process makes the compression process closer to isothermal compression, thereby reducing power consumption and improving the operational efficiency and economy of the entire compressor system. Separating condensate When the gas temperature drops, the water vapor and oil-gas mixture contained therein will condense. Some lubricating oil and water will condense into droplets, which can then be separated out, making the output compressed air cleaner. By effectively controlling the gas temperature, risks such as lubricant failure, equipment component damage, and even explosion caused by excessively high temperatures can be prevented. At the same time, the pollution risks to downstream equipment and pipelines can also be reduced.

The air compressor regular maintenance kit is designed to ensure the normal operation of the air compressor and extend its service life.

Attention to the Atlas Copco Adsorption Dryer Silencer: During installation, ensure that the sealing gasket is intact to prevent air leakage, which could lead to increased noise and reduced regeneration efficiency; Do not replace it with an incompatible model at will (for example, if the diameter is too small, it will cause excessive exhaust resistance, affecting the regeneration effect of the adsorbent); The original factory silencer is usually designed with acoustic optimization, not only providing better noise reduction effects, but also ensuring the smoothness of the regeneration exhaust and maintaining the normal cycle of the dryer.

Maintenance recommendations for the oil filter of Atlas Copco screw air compressors: Replacement cycle: Under normal operating conditions, replace the filter once every 2,000 - 3,000 hours. In harsh environments (such as high dust and high temperature), this period should be shortened to 1,500 hours. Synchronous operation: When replacing the filter element, also simultaneously discharge the settled oil at the bottom of the oil tank (containing a large amount of impurities) and refill the oil to the specified level. Selection requirements: It is necessary to select original factory or certified filter elements that match the compressor model to avoid equipment damage due to size mismatch or insufficient filtration accuracy. Effective maintenance of the oil filter can significantly reduce the wear rate of the screw main unit and is a key aspect of the daily maintenance of the compressor unit with low cost and high efficiency.

Common Faults and Solutions of Atlas Copco Air Compressor Pressure Gauges Pointer not moving or stuck Reason: Internal gears stuck, spring tube damaged, interface blocked (impurities or condensate water frozen). Solution: Disassemble and clean, remove the blockage; replace the gauge if severely damaged. Incorrect or drifting reading Reason: Elastic element fatigue (long-term use), pointer loose, drastic changes in environmental temperature. Solution: Re-calibrate; replace aging components or pressure gauge. Shell leakage Reason: Sealing of shock-resistant gauge is poor, screws of the shell are loose. Solution: Add silicone oil / glycerin and seal; tighten the screws; replace the shell if severely damaged.

Atlas Copco 2906044800，The Atlas Copco cooler is an essential component of the air compressor, responsible for dissipating the heat generated by the compressor into the environment to maintain the normal operating temperature of the air compressor. However, over time, the surface of the cooler will accumulate a large amount of dust, oil stains, and other impurities, which will hinder the heat dissipation and cause the air compressor's temperature to rise, thereby affecting its performance and lifespan. It is particularly important to clean the air compressor cooler regularly. Through cleaning, the impurities on the surface of the cooler can be removed, restoring its heat dissipation performance, thereby reducing the operating temperature of the air compressor, improving its efficiency and stability.