China atlas copco air compressor details Manufacturer, Supplier, Factory

Maintenance and precautions for the control unit of Atlas Copco air compressors Regularly check the display screen and buttons of the control unit to ensure they are functioning properly and that the heat dissipation and ventilation are adequate, to prevent the impact of high temperatures on performance. If a fault code appears, it is recommended to refer to the equipment manual for interpretation or contact the authorized service center of Atlas Copco for handling to avoid the expansion of problems due to self-operation. Some control units support firmware upgrades, and updates can be obtained through official channels to enhance functional stability.

Atlas Copco Daily Maintenance: Manual Drain Valve: Drain at least 1-2 times per day. The drainage effect is better after the machine is shut down (at this time, the system pressure is low and water is easier to be discharged). Automatic Drain Valve: Check once a week. Clean the impurities (such as oil stains, rust) in the filter or float ball to prevent blockage. Electronic Drain Valve: Regularly check if the timer settings are reasonable, clean the electromagnetic valve valve core to ensure smooth operation. When the ambient temperature is below 0℃, take measures such as insulation or heating to prevent the drainage port from freezing and getting clogged.

Maintenance precautions for the load reduction device kit of Atlas Copco air compressors: Regularly clean the internal components of the load reducer to prevent the accumulation of oil and impurities, which could cause valve sticking or malfunction. Check the integrity of the seals and replace aging parts in time to avoid pressure control accuracy being affected by leakage. During commissioning, calibrate the pressure setting value according to the equipment manual to ensure accurate loading/unloading switching and avoid frequent start-stop or excessive pressure fluctuations.

If the muffler is clogged or damaged, it will cause an increase in intake/exhaust resistance, which may affect the gas production efficiency of the air compressor. Regular inspection and maintenance are necessary. For large air compressor systems, it is recommended to adopt comprehensive noise reduction measures such as soundproof rooms and vibration isolators for better results.Well-known brands (such as Atlas Copco, Ingersoll Rand, etc.) all have corresponding air compressor mufflers. Depending on the specific model, original factory parts or third-party products that meet the specifications can be selected.

Atlas Copco Gear Maintenance Tips Regular Inspection: Observe the condition of the gear tooth surface, measure the tooth clearance, and replace them immediately if any abnormalities are found. Lubrication Management: Use dedicated gear oil (or air compressor-specific oil), replace it regularly, and keep the oil level normal to avoid oil contamination. Installation Calibration: Ensure that the parallelism and perpendicularity of the gear shaft meet the requirements, and avoid uneven load operation. Load Control: Prevent the air compressor from operating under long-term overloading conditions, and reduce the fatigue damage to the gears. The design and maintenance of air compressor gears are crucial for the overall performance of the machine. High-precision gear combinations with a good lubrication system can significantly reduce operating noise, extend service life, and ensure the efficient and stable operation of the air compressor.

Genuine Original Atlas Copco Parts by reliable China supplier: If you are still looking for a reliable supplier from China who can provide you worry-free Atlas Copco products with best prices, you are on the right page. Here lets present you with the 2906075200 Atlas Copco GA132-180W Oil Separator Kit.