China atlas copco air compressor distributors Manufacturer, Supplier, Factory

3002619010 Atlas Copco Maintenance and Replacement Guidelines Synchronous Replacement: It is recommended to replace the air filter, oil filter, and lubricating oil at the same time to reduce the oil pressure difference and energy consumption. Installation and Sealing: Install according to the manual torque. Replace all O-rings to avoid bypass of unfiltered air or oil. Pressure Difference Monitoring: Pay attention to the oil pressure difference and fuel consumption. If it abnormally increases, stop the machine for inspection and replacement. Environment and Load: In high dust / high humidity or heavy load conditions, the replacement cycle can be shortened to 3500 - 4000 hours or less.

The component design of Atlas Copco dryers emphasizes compatibility with air compressor systems. By optimizing heat exchange efficiency, adsorbent performance and automatic control logic, it achieves low energy consumption and high stability in the drying process of compressed air.

Atlas Copco Gear Trial Run and Inspection Preliminary Inspection Manually rotate the gear shaft to feel if the rotation is smooth, and check for any sticking, abnormal noise or eccentric vibration. Check if the lubrication path in the gearbox is unobstructed, and add gear oil to the standard level as per the regulations. No-load Trial Run Connect the power supply and conduct a short-term (5-10 minutes) no-load operation. Listen for any abnormal noises (such as metal friction sounds, high-frequency squeals) from the gearbox. After stopping the machine, check the temperatures of the bearings and gears (should not exceed the ambient temperature by 40°C), and observe for any oil leakage. Load Test Gradually load to the rated pressure and run for more than 30 minutes. Recheck the noise, temperature and sealing conditions, and confirm there are no abnormalities.

Atlas Copco 2906030100 ,The principle of the air compressor maintenance kit: Replace worn parts, perform maintenance and troubleshooting, ensure safety,Air filter element Remove garbage from the bottom. The filter with grease needs to be soaked in foam-free detergent. Damaged filters need to be replaced. Oil separator To ensure high efficiency of oil-gas separation, it is necessary to pass the compressed gas from the collision and gravity separation compressor through the oil separation process. Safety valve It is necessary to ensure the quality and safety of pressure vessels. Professional adjustments are required. Lubrication system Test the oil quality with screw oil and maintain the lubrication of bearings and the lifespan of the compressor Maintenance process standardization 1. Shut down and power off: Turn off the power and hang warning signs 2. System depressurization: Close the water supply and gas supply valves 3. Disassembly and inspection: Use tools to disassemble the components. It is necessary to check the rotor alignment status and bearing damage 4. Component maintenance: Replace the filter and lubricate, etc

If you are searching for 1622507380 AIR FILTER – Atlas Copco China Supplier, You are Come to the right place. we provide you Genuine Original Atlas Copco Air Filter and Other’s Parts. GA30, GA37, GA45+basically use this air filter. The air filter assembly is 1622507380=1622507300, and the internal filter element is 1613740800=1613740700. Check the blow is specific data for you to cross-check.

The air compressor temperature sensor is an important component used for real-time monitoring of the temperatures of key parts of the compressor unit (such as exhaust temperature, oil temperature, and motor temperature, etc.). Its core function is to detect temperature changes and provide data support for the control system, ensuring that the equipment operates within a safe temperature range. At the same time, when abnormal temperatures occur, it triggers protection mechanisms (such as shutdown and alarm) to prevent mechanical failures or safety risks caused by overheating.