China air compressor atlas copco catalogue Manufacturer, Supplier, Factory

For specific models, installation specifications or replacement information, it is recommended to provide the complete model of the equipment (such as the model of the dryer and air compressor), or refer to the component numbers in the official technical manual of Atlas Copco to ensure a proper selection. Low-temperature environments have a high requirement for the reliability of sensors, so it is advisable to choose original factory parts to ensure system compatibility and service life.

Genuine Original Atlas Copco Parts by reliable China supplier: If you are still looking for a reliable supplier from China who can provide you worry-free Atlas Copco products with best prices, you are on the right page. Here lets present you with the 2906075200 Atlas Copco GA132-180W Oil Separator Kit.

The 4000-hour oil filter usage recommendation for Atlas Copco: It is necessary to replace the filter according to the equipment manual, taking into account the operating time and actual oil condition. Even if it has not reached 4000 hours, if you find that the filter is clogged or the pressure difference is too high, you should replace it promptly. When replacing, it is necessary to use original factory parts to ensure the filtering performance and equipment safety. Avoiding failures such as main unit wear caused by inferior filters.

Atlas Copco 2906049900,The principle of the air compressor maintenance kit: Replace worn parts, perform maintenance and troubleshooting, ensure safety,Air filter element Remove garbage from the bottom. The filter with grease needs to be soaked in foam-free detergent. Damaged filters need to be replaced. Oil separator To ensure high efficiency of oil-gas separation, it is necessary to pass the compressed gas from the collision and gravity separation compressor through the oil separation process. Safety valve It is necessary to ensure the quality and safety of pressure vessels. Professional adjustments are required. Lubrication system Test the oil quality with screw oil and maintain the lubrication of bearings and the lifespan of the compressor Maintenance process standardization 1. Shut down and power off: Turn off the power and hang warning signs 2. System depressurization: Close the water supply and gas supply valves 3. Disassembly and inspection: Use tools to disassemble the components. It is necessary to check the rotor alignment status and bearing damage 4. Component maintenance: Replace the filter and lubricate, etc.

Atlas Copco 2906035200,The intake valve is the "breathing hole" of the air compressor, responsible for controlling the amount of fresh air intake to ensure the normal operation of the compressor and the output of compressed gas meeting the requirements. The intake valve is controlled on and off by the solenoid valve to achieve automatic loading and unloading of the compressor 5. When the pressure does not reach the set value, the intake valve is fully opened for loading; when the pressure is too high, it automatically unloads to protect the equipment and reduce energy consumption. The intake valve regulates the intake volume to control the output pressure and flow of the compressor, meeting the needs of different working conditions. The intake valve is equipped with a check valve to prevent reverse flow of compressed air and avoid damage to the exhaust system. The bypass valve of the intake valve is open during no-load or shutdown to prevent the formation of a vacuum in the separation oil tank and ensure the normal atomization and circulation of lubricating oil.

Atlas Copco Daily Maintenance: Manual Drain Valve: Drain at least 1-2 times per day. The drainage effect is better after the machine is shut down (at this time, the system pressure is low and water is easier to be discharged). Automatic Drain Valve: Check once a week. Clean the impurities (such as oil stains, rust) in the filter or float ball to prevent blockage. Electronic Drain Valve: Regularly check if the timer settings are reasonable, clean the electromagnetic valve valve core to ensure smooth operation. When the ambient temperature is below 0℃, take measures such as insulation or heating to prevent the drainage port from freezing and getting clogged.