China 2906024000 Manufacturer, Supplier, Factory

The oil filter element of Atlas Copco air compressors (Common Problems and Failure Causes) The filter element gets clogged prematurely Reasons: Excessive environmental dust (unfiltered intake air), excessive oil addition or mixing of different brand oils leading to emulsification, increased internal wear . Treatment: Improve environmental cleanliness, standardize oil usage, inspect worn components. Poor filtering effect Reasons: Using inferior filter elements , seal ring not properly aligned during installation , bypass valve always open. Treatment: Select original factory or high-quality aftermarket filter elements, ensure proper installation sealing, regularly check bypass valve function. Filter element rupture Reasons: Installation too tight, abnormal system pressure increase, insufficient strength of filter element material. Treatment: Standardize installation torque, check oil pressure control system, replace with qualified filter element.

Atlas Copco 2901021800 Original: The core control components use original parts to ensure compatibility and reliability with the system. Non-original parts may pose a risk of parameter deviation.

Atlas Copco V-BELT (SET 2X) XPZ Maintenance Points: During installation, ensure the appropriate tension is maintained. Insufficient tension will cause the belt to slip, affecting the transmission efficiency. Excessive tension will increase the load on the bearings, shortening the lifespan of the belt and the bearings. During use, regularly check the wear condition of the belt. If cracks are found on the surface of the belt, severe wear, or slipping occurs, it is necessary to replace it promptly. At the same time, keep the belt clean to avoid the attachment of oil stains, dust and other impurities on the belt, which will affect its transmission performance.

Atlas Copco confirms the type of lubricating grease Based on the type of air compressor components and operating conditions , select the matching special lubricating grease . It is strictly prohibited to mix different types or grades of lubricating grease . Check the parameters of the lubricating grease: such as applicable temperature range, pour point , and penetration . Atlas Copco cleans the components to be lubricated Stop the machine and ensure the components are completely cooled. Use oil-free cotton cloth or dedicated cleaning agents to wipe the old lubricating grease, oil stains, dust, and metal debris on the surface of the components, especially the key areas such as the bearing seat and the meshing surface of the gears, which need thorough cleaning .

Installation and Maintenance of Atlas Copco Screw Air Compressor Regulators During installation, ensure that the connection between the regulator, the air compressor, and the pipelines is sealed properly to prevent air leakage and affect accuracy. Regularly clean the sensing components of the regulator (such as diaphragms and sensors) to prevent impurities from blocking or wearing them out. For mechanical regulators, check the spring elasticity to ensure it is normal; for electronic ones, perform regular sensor calibration. If you encounter problems such as excessive pressure fluctuations or malfunctioning regulation, promptly repair or replace the regulator. When choosing an air compressor regulator, consider factors such as the power of the air compressor, the pressure requirements of the gas-using equipment, and the operating environment to ensure efficient and stable system operation.

Common Misconceptions and Risks Replacing only the oil but not the filter: Impurities accumulate, accelerating wear and clogging. Overdue use: Increased pressure difference leads to higher energy consumption and an increased risk of filter damage. Installation too tightly: May cause the base to deform or make future disassembly difficult.