China 2901161700 Manufacturer, Supplier, Factory

A high powered modified engine tends to generate excessive blow-by oil and gasses. In these cases, an ordinary small catch can may quickly fill with oil and not be adequate. Like the Radium Engineering Catch Cans, the AOS-R (Air Oil Separator, Return) is responsible for keeping blow-by oil and other pollutants out of the air intake, intercooler, manifold, etc. The main difference is that an AOS-R system returns oil back into the pan above the oil level. This permits a service-free system.

Atlas Copco Oil Separator Element Kit for Old Style GA Series Rotary Screw Compressors - 2901 1963 00

Daily Maintenance of Air Compressor Intake Valve by Atlas Copco Regular Cleaning: The intake valve is prone to contamination from dust and impurities in the air. It should be disassembled and cleaned regularly to prevent the valve core from getting stuck and affecting normal operation. Check Seals: Aging or damaged sealing components such can lead to air leakage. Regular inspections and timely replacements are necessary. Lubrication Maintenance: For intake valves with moving parts, lubricants should be added according to the instructions to ensure smooth operation. Function Testing: Regularly test the smoothness of the valve's opening and closing and its response time to ensure it can accurately act according to pressure changes. If the intake valve malfunctions, it may cause problems such as insufficient air output, unstable pressure, increased energy consumption, and even affect the lifespan of the entire machine. Therefore, daily maintenance and upkeep are particularly important.

Atlas Copco 1088000053，The contactor is one of the core components of the electrical control system of an air compressor. Essentially, it is an electromagnetic switch that controls a larger current using a smaller current. It is specifically used to control the start, operation, and stop of the main motor of the air compressor. The contactor not only can connect and disconnect circuits, but also has low-voltage release protection function. In electrical engineering, because it can quickly cut off the main circuits of AC and DC and can frequently connect and control circuits with large currents (up to 800A), it is often used as a control object for electric motors, and can also be used as a control device for factory equipment, electric heaters, work machines, and various power units and other power loads. The contactor has a large control capacity and is suitable for frequent operations and remote control. It is one of the important components in the automatic control system.

Usage and Maintenance Notes Strictly match the model Different series of air compressors (such as GA, GHS, ZR, etc.) require the use of corresponding model-specific oils. Mixing or using the wrong type may cause equipment damage and affect warranty. Regular replacement and inspection Replace according to the specified cycle in the equipment manual (synthetic oil usually has a longer cycle than mineral oil), and replace oil filters, air filters, etc. at the same time. Regularly test the oil quality (such as viscosity, moisture content, impurity content) to avoid failures caused by deteriorated oil. Storage and refilling The oil needs to be stored in a sealed manner in a cool and dry place to avoid contamination; when refilling, ensure that the tools are clean to prevent impurities from entering the oil circuit system.

Replacement and Maintenance Key Points 2901195700 Atlas Copco Replacement Cycle: 4000 - 6000 hours or replace as needed annually; for high dust / high humidity or heavy load conditions, it can be shortened to 3500 - 4000 hours. Installation and Sealing: Install according to the manual torque, replace all O-rings, avoid unfiltered air or oil bypass. Pressure Difference Monitoring: Pay attention to the oil pressure difference and fuel consumption, if it abnormally increases, stop the machine for inspection and replacement. 2901195700 Atlas Copco Companion Replacement: It is recommended to replace simultaneously with air filter, oil filter, and lubricating oil to reduce the oil pressure difference and energy consumption.