China Oil Free Reciprocating Compressor Manufacturer, Supplier, Factory

If you need to purchase Atlas Copco products or replace the screws of Atlas Copco air compressors, it is recommended that you select products with matching specifications and performance based on the model of the air compressor, specific components, and the regulations in the equipment manual, in order to ensure the safe and stable operation of the air compressor.

The control unit of Atlas Copco's injection-type screw compressors is designed with intelligence, which not only simplifies operation management but also significantly improves the operating efficiency and reliability of the equipment. It is a key guarantee for achieving the "efficient, energy-saving, and safe" operation of the compressors. When choosing, it is necessary to match the corresponding specification of the control unit according to the compressor model and actual working conditions.

Atlas Copco 2906039200 ,The principle of the air compressor maintenance kit: Replace worn parts, perform maintenance and troubleshooting, ensure safety,Air filter element Remove garbage from the bottom. The filter with grease needs to be soaked in foam-free detergent. Damaged filters need to be replaced. Oil separator To ensure high efficiency of oil-gas separation, it is necessary to pass the compressed gas from the collision and gravity separation compressor through the oil separation process. Safety valve It is necessary to ensure the quality and safety of pressure vessels. Professional adjustments are required. Lubrication system Test the oil quality with screw oil and maintain the lubrication of bearings and the lifespan of the compressor Maintenance process standardization 1. Shut down and power off: Turn off the power and hang warning signs 2. System depressurization: Close the water supply and gas supply valves 3. Disassembly and inspection: Use tools to disassemble the components. It is necessary to check the rotor alignment status and bearing damage 4. Component maintenance: Replace the filter and lubricate, etc

All these filter components must be equipped with original Atlas Copco parts to ensure filtration efficiency and equipment compatibility. During maintenance, it is necessary to check and replace them according to the specified cycle in the equipment manual to avoid equipment failure due to filter failure.

Atlas Copco Installation and Maintenance Guidelines During installation, it is necessary to clean the oil stains and impurities from the surface of the distance ring, ensuring a tight fit with the mating parts without any gaps or skew. Avoid striking the edge of the distance ring (especially thin-walled parts), as this may cause deformation and affect the dimensional accuracy. During maintenance and inspection, check if the distance ring is worn, deformed or cracked. If any abnormalities are found, it should be replaced promptly; otherwise, it may lead to a decrease in the assembly quality and operational stability of the air compressor, causing vibration, abnormal noise or leakage, etc. Although the distance ring is a small standard part, its accuracy directly affects the assembly quality and operational stability of the air compressor. When selecting and installing, it is necessary to strictly follow the requirements of the equipment manual.

Key Points for Bolt Installation and Maintenance of Atlas Copco Pre-tightening Torque: Appropriate torque should be applied according to the bolt's strength grade and connection requirements . Excessive torque can cause the bolt to break, while insufficient torque may result in poor sealing or loosening. Surface Treatment: The bolt surface is usually galvanized, phosphated , or oxidized . Before installation, check the surface for rust or damage. Cooperation Precision: The cooperation between the bolt and the nut or the bolt hole must comply with standards . Avoid overly loose or overly tight threads. Regular Inspection: After the air compressor has been running for a period of time, check if the bolts are loose. If rust, deformation, or fracture is found, replace the bolts of the same specification and strength in a timely manner.