China Atlas Copco Water Lever Transducer Manufacturer, Supplier, Factory

Common faults and maintenance of the electromagnetic valves in Atlas Copco oil-separation type air compressors: The valve core may get stuck due to accumulated oil, or the sealing parts may age and cause leakage, which will affect the efficiency of oil-gas separation. Regular inspection and cleaning are necessary. If the valve fails to operate properly, check whether the power supply is normal and if the valve body is blocked. When replacing, it is essential to use the original factory electromagnetic valves to ensure compatibility with the oil-gas separation system and avoid excessive oil content in the compressed air or abnormal operation of the equipment.

Replacement and precautions for the oil filter housing of Atlas Copco screw-type air compressors Part matching: It is necessary to use the original Atlas Copco housing module to ensure complete matching with the model and filter cartridge model (for example, the housing specifications of different power models of the GA series are different). Installation guidelines: Clean the internal oil stains and impurities of the housing during replacement, and check if the sealing surface is flat. The new housing needs to be properly coated with sealant (if necessary) or installed with new O-rings to avoid leakage. Tighten the filter cartridge with the specified torque to prevent over-tightening from damaging the housing threads or under-tightening causing leakage. Regular inspection: During each oil filter cartridge replacement, simultaneously check for any cracks or deformations in the housing, whether the sealing parts are intact, and ensure the reliable operation of the oil circuit system.

Usage and Maintenance Notes Strictly match the model Different series of air compressors (such as GA, GHS, ZR, etc.) require the use of corresponding model-specific oils. Mixing or using the wrong type may cause equipment damage and affect warranty. Regular replacement and inspection Replace according to the specified cycle in the equipment manual (synthetic oil usually has a longer cycle than mineral oil), and replace oil filters, air filters, etc. at the same time. Regularly test the oil quality (such as viscosity, moisture content, impurity content) to avoid failures caused by deteriorated oil. Storage and refilling The oil needs to be stored in a sealed manner in a cool and dry place to avoid contamination; when refilling, ensure that the tools are clean to prevent impurities from entering the oil circuit system.

1617965500 Atlas Copco Installation Location: The filter element can be installed at any position in the compressed air system. It can be standardly equipped on the after-cooler and is highly flexible to use. It can effectively protect the compressed air system as well as components such as dryers and filters.

The Atlas Copco C242 screw air compressor discharge valve repair kit is applicable for maintenance recommendations. Applicable models: Specifically designed for the C242 screw air compressor model. It is necessary to confirm the specific production batch and discharge valve model of the equipment (this can be verified through the equipment serial number or part number). Replacement Timing： When there are abnormal compressor pressure， significant pressure remaining during discharge， slow loading response or abnormal air leakage sounds， etc.， it may indicate that the discharge valve needs maintenance or replacement of components. At this time， this kit can be used for maintenance. Installation note： It is recommended to operate by professional technicians according to the original factory maintenance manual to ensure correct assembly and avoid secondary faults caused by improper installation.

Maintenance and Fault Handling of the Oil Temperature Electronic Elektronikon Control Module of Atlas Copco Air Compressors If there are abnormal oil temperature readings, the heating/cooling system does not respond, or the oil temperature protection is triggered frequently, it may be related to this control module. Maintenance suggestions: First, check whether the oil temperature sensor and connection lines are normal. Eliminate front-end signal faults; If the module itself is faulty, it is recommended to replace the original factory parts to ensure control performance. After replacement, calibration of parameters through special tools is required to make it match the model; Regularly check the module status through the self-check function of the Elektronikon system to promptly detect potential problems.