China Atlas Copco Minimum Pressure Valve Kit Manufacturer, Supplier, Factory

The air compressor pressure sensor is for installation and maintenance. Installation location: It is usually installed at the outlet of the storage tank, the exhaust port of the compressor, or on the main pipeline to ensure that the sensor can accurately reflect the system pressure and avoid direct exposure to high temperatures, oil stains, or severe vibrations. Regular calibration: To ensure measurement accuracy, the sensor should be calibrated regularly (generally once or twice a year) to prevent control failure due to drift. Daily inspection: Check if the sensor wiring is loose and the seal is good to avoid affecting measurement accuracy due to air leakage or poor contact; if any abnormal display or no signal output is found for the sensor, it is necessary to promptly troubleshoot the fault or replace it.

Installation and Maintenance: Select the corresponding specification of shock absorbers based on the model and weight of the equipment to ensure uniform force application during installation. After long-term use, check if the rubber has aged, cracked or deformed. If the performance deteriorates, replace the original factory parts in time to maintain the shock absorption effect.

Key points for replacement and maintenance: Selection matching: Use the original factory connectors of the corresponding model. Confirm the interface specifications, pressure grade and material. Avoid leakage or connection failure due to mismatched dimensions. Installation guidelines: Pneumatic/oil circuit connectors: Wrap sealing tape or replace the new seal, tighten according to the specified torque, avoid over-tightening which may cause thread damage. Electrical connectors: Ensure the pins are aligned, prevent damage caused by forced insertion or removal, tighten the locking structure . Regular inspection: During daily maintenance, check if the connectors are loose, corroded or overheating . Address abnormal situations promptly.

Atlas Copco Gear Maintenance Tips Regular Inspection: Observe the condition of the gear tooth surface, measure the tooth clearance, and replace them immediately if any abnormalities are found. Lubrication Management: Use dedicated gear oil (or air compressor-specific oil), replace it regularly, and keep the oil level normal to avoid oil contamination. Installation Calibration: Ensure that the parallelism and perpendicularity of the gear shaft meet the requirements, and avoid uneven load operation. Load Control: Prevent the air compressor from operating under long-term overloading conditions, and reduce the fatigue damage to the gears. The design and maintenance of air compressor gears are crucial for the overall performance of the machine. High-precision gear combinations with a good lubrication system can significantly reduce operating noise, extend service life, and ensure the efficient and stable operation of the air compressor.

Advantages of Original Factory Bearings Precise Matching: Atlas Copco original factory bearings are precisely matched with the design parameters of the equipment (such as speed, load, and clearance), which can maximize the performance of the unit and prevent early failures caused by size or performance mismatch. Quality Control: Using high-quality bearing steel (such as GCr15SiMn), they undergo strict heat treatment and precise processing to ensure wear resistance, stability, and service life (typically designed for a service life of 20,000 - 40,000 hours). Certification Compliance: Compliant with international standards such as ISO and CE, and passing Atlas Copco's own rigorous tests (such as vibration and temperature cycling tests), meeting the requirements of industrial-level continuous operation.

Recommendation for Selecting Special Pressure Sensors for Atlas Copco Screw Air Compressors It is essential to use original Atlas Copco pressure sensor spare parts. These parts have undergone rigorous precision calibration and environmental adaptability tests, ensuring compatibility with the compressor control system and measurement accuracy. Third-party parts may have issues such as insufficient precision, signal mismatch, or short lifespan, which can easily lead to control failure or equipment malfunctions, thereby affecting the safe and stable operation of the air compressor.