China atlas copco ga 75 compressor parts Manufacturer, Supplier, Factory

Atlas Copco Common Problems and Solutions Slip and Abnormal Noise: This is often caused by loose belts, oil contamination, or wear on the pulley grooves. Adjust the tension, clean, or replace the pulley. Excessive Breakage: This may be due to excessive tension, incorrect belt type, misaligned pulley grooves, or excessive load. Check and adjust as necessary. Severe Heating: This is usually caused by slipping or poor heat dissipation. Stop the machine immediately for inspection.

Atlas Copco Daily Maintenance: Manual Drain Valve: Drain at least 1-2 times per day. The drainage effect is better after the machine is shut down (at this time, the system pressure is low and water is easier to be discharged). Automatic Drain Valve: Check once a week. Clean the impurities (such as oil stains, rust) in the filter or float ball to prevent blockage. Electronic Drain Valve: Regularly check if the timer settings are reasonable, clean the electromagnetic valve valve core to ensure smooth operation. When the ambient temperature is below 0℃, take measures such as insulation or heating to prevent the drainage port from freezing and getting clogged.

By using the original Atlas Copco filter kits or service kits, the failure rate of the equipment can be effectively reduced, its service life can be prolonged, and the quality of compressed air can be maintained. This is particularly suitable for industrial scenarios where high reliability of equipment is required.

Although the seals of Atlas Copco are considered wear-prone parts, they are crucial for the efficient and safe operation of the air compressor. Proper selection, regular replacement, and standardized installation can effectively reduce leakage faults, lower energy consumption and maintenance costs.

Atlas Copco Maintenance and Replacement Recommendations Replacement Cycle: it is recommended to replace the filter according to the specified cycle in the unit maintenance manual . If the dust concentration in the usage environment is high, the replacement cycle should be shortened . Condition Judgment: Some models are equipped with an air filter pressure differential indicator. When the indicator value exceeds the set threshold, it indicates that the filter is clogged and needs to be replaced immediately; without an indicator, regularly disassemble and inspect the accumulated dust on the filter material surface. If it is obviously clogged or damaged, replace it immediately. Replacement Precautions: Before replacement, the unit must be shut down and the power disconnected to ensure safety. During installation, clean the impurities around the air inlet to avoid contaminants from falling into the air intake pipe during disassembly and assembly.

Atlas Copco Maintenance Tips: Regular Inspection: Remove the cylinder cover and clean the valve surface of oil stains and carbon deposits (especially for piston-type air compressors, as high-temperature lubricating oil can easily cause carbon deposits); Replace Wear Parts: Valve plates, springs, sealing gaskets, etc. are considered wear parts. When wear, deformation or aging is detected, they should be replaced in time; Keep Clean: Avoid introducing impurities during installation. The filter device of the intake system needs regular maintenance to reduce dust entering the cylinder. Although the cylinder cover valve is a small component, it directly affects the compression efficiency and operational stability of the entire machine. During daily maintenance, special attention should be paid to its sealing performance and operational flexibility. If any abnormalities occur, timely repairs should be carried out to extend the service life of the air compressor.