China atlas copco air compressor gx11ff manual Manufacturer, Supplier, Factory

Atlas Copco Air Compressor Oil Check Valve Maintenance and Replacement Check Period: It is recommended to conduct checks every 1-2 years or in accordance with the equipment manual (for example, after 4000-8000 hours of operation), and perform the checks simultaneously when replacing the filter and oil. Maintenance Points: Clean the valve core and valve seat to remove impurities; Check the wear of the seals and replace them promptly if they are aged; Test the elasticity of the springs. If the elasticity is insufficient, replace the entire valve. Replacement Precautions: Select original factory parts that match the model (such as Atlas Copco, Ingersoll Rand, etc. have dedicated oil check valves). Ensure that the size and pressure parameters are consistent; Pay attention to the direction during installation, and avoid installing it in the wrong direction; After replacement, start the equipment and check if the oil circuit pressure is normal and if there is any leakage.

Maintenance suggestions: During installation, it is necessary to check whether the sealing surface of the flange is in good condition. Use the original factory sealant gasket and tighten the bolts according to the specified torque. This is to prevent air leakage or damage to the components due to improper installation.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.

Replacement and Maintenance: Gaskets are wear-prone parts. They should be checked and replaced promptly during regular maintenance of the air compressor or when leakage occurs. During the replacement process, ensure the installation surface is clean to avoid poor sealing due to impurities. Also, follow the specifications in the equipment manual for proper operation to ensure a proper installation.

The Atlas Copco Qas60 lubricating oil filter 1092471700 is an original lubricating oil filter component designed by Atlas Copco for its Qas60 series of equipment.

Atlas Copco Z160-275 transmission shaft bearing kit usage and maintenance precautions: When replacing, it must be operated by professional technicians. Follow the steps in the equipment maintenance manual strictly to ensure that the bearings are installed properly and the clearance is adjusted reasonably. Before installation, clean the transmission shaft and bearing housing, and check whether the relevant mating surfaces are intact to avoid impurities or damage affecting the bearing lifespan. It is recommended to conduct regular inspections in combination with the overall maintenance cycle of the equipment. If abnormal bearing noise or abnormal temperature rise is detected, the kit should be replaced promptly.