China Air Compressor Oil Temperature Manufacturer, Supplier, Factory

The Atlas Copco DRAIN HDF120-AC drain valve adopts an electronic timed drainage system, providing reliable performance without the need for manual drainage. It has an IP65 protection rating for the housing, effectively preventing dust and moisture from entering, and is suitable for various industrial and outdoor applications. Its compact design saves space and is easy to install in existing compressed air configurations, with low maintenance requirements. Additionally, the DRAIN HDF120-AC reduces air loss during drainage and offers energy-saving benefits.

Regularly replacing the Atlas Copco original oil separator kit is crucial for maintaining the efficient and stable operation of the GA90-110(W) series air compressors. It can reduce the failure rate, extend the equipment lifespan, and ensure the quality of compressed air.

Troubleshooting and Replacement Suggestions: Common Issues and Solutions: Stalling or Leakage: Causes unstable pressure and increased energy consumption. It is recommended to disassemble and clean or replace directly (it is suggested to replace the entire set to avoid matching issues between new and old components). Reduced Adjustment Precision: Mostly due to wear of sensors or valve cores. Replacement of the original kit is required and recalibration is necessary. Installation Tips: After replacement, parameter matching through the controller (such as setting pressure upper and lower limits) is necessary to ensure normal system linkage.

Never forget to order a spare part and avoid unplanned downtime. As your original equipment manufacturer, we know exactly which parts are needed for every service intervention. These are offered as a single maintenance kit with the quality assurance of genuine Atlas Copco parts.

The sealing rings of the Atlas Copco 0650100087 air compressor are made of nitrile rubber and fluorine rubber. They have excellent oil resistance and wear resistance; while the fluorine rubber can withstand higher temperatures and more demanding chemical environments.

Replacement and selection suggestions for flat washers of Atlas Copco air compressors When replacing, it is necessary to strictly match the original specifications to avoid sealing failure or connection loosening due to size mismatch. For high-pressure, high-temperature or areas in contact with compressor oil, it is recommended to use original factory metal flat washers to ensure that the material is oil-resistant and pressure-resistant. If it is a critical sealing part (such as the end cover of the oil-gas separator), check whether the surface of the washer is flat, without scratches or deformation. If necessary, replace the new part to ensure the seal. For specific models or part numbers, you can refer to the parts manual of the air compressor (usually identified by a numerical code, such as 0650 series, 1622 series), or consult the Atlas Copco after-sales service for the equipment model to obtain precisely matched parts.