China Air Compressor FILTER KIT DD/DDP 130+ Manufacturer, Supplier, Factory

all products are sourced directly from authorized retailers in the Belgium, Germany, China. We maintain strict quality control processes and verify each product before shipping. All items come with applicable manufacturer warranties and are covered by our standard return policy.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.

Atlas Copco Heavy Duty Screw Element C168 pin:1616725691-1616725681 When you are searching for the genuine Airend for Atlas Copco Heavy Duty Compressors , Part numbers: “P/N 1616725691-1616725681 Air End” or any other screw elements, you are lucky to find Taike China. With our own distribution network, our prices are unbeatable in China.You can rest assured to buy Atlas Copco 1616734582 - 1616734592 C190 Screw Element from our factory. 

Atlas Copco Z160-275 transmission shaft bearing kit usage and maintenance precautions: When replacing, it must be operated by professional technicians. Follow the steps in the equipment maintenance manual strictly to ensure that the bearings are installed properly and the clearance is adjusted reasonably. Before installation, clean the transmission shaft and bearing housing, and check whether the relevant mating surfaces are intact to avoid impurities or damage affecting the bearing lifespan. It is recommended to conduct regular inspections in combination with the overall maintenance cycle of the equipment. If abnormal bearing noise or abnormal temperature rise is detected, the kit should be replaced promptly.

Maintenance and precautions for the control unit of Atlas Copco air compressors Regularly check the display screen and buttons of the control unit to ensure they are functioning properly and that the heat dissipation and ventilation are adequate, to prevent the impact of high temperatures on performance. If a fault code appears, it is recommended to refer to the equipment manual for interpretation or contact the authorized service center of Atlas Copco for handling to avoid the expansion of problems due to self-operation. Some control units support firmware upgrades, and updates can be obtained through official channels to enhance functional stability.

The electromagnetic valve maintenance kit for Atlas Copco EWD330 electronic drainage valve is applicable for maintenance suggestions. Applicable models: Only applicable to Atlas Copco EWD330 type electronic drainage valve. Before purchase, it is necessary to confirm the production batch and electromagnetic valve specification of the drainage valve to avoid model mismatch. Maintenance timing: When the drainage valve shows slow operation, abnormal drainage (such as no drainage or continuous drainage), abnormal noise from the electromagnetic valve, or air leakage, it may be necessary to repair the electromagnetic valve. At this time, this kit can be used to replace the worn parts. Installation note: It is recommended to operate by professionals. Before maintenance, cut off the power and air source, assemble in accordance with the original factory manual specifications, ensure that the components are installed properly, and avoid functional failure or safety hazards due to improper assembly.