China 2906054300 SERVICE KIT Manufacturer, Supplier, Factory

Atlas Copco Installation and Maintenance Guidelines During installation, it is necessary to clean the oil stains and impurities from the surface of the distance ring, ensuring a tight fit with the mating parts without any gaps or skew. Avoid striking the edge of the distance ring (especially thin-walled parts), as this may cause deformation and affect the dimensional accuracy. During maintenance and inspection, check if the distance ring is worn, deformed or cracked. If any abnormalities are found, it should be replaced promptly; otherwise, it may lead to a decrease in the assembly quality and operational stability of the air compressor, causing vibration, abnormal noise or leakage, etc. Although the distance ring is a small standard part, its accuracy directly affects the assembly quality and operational stability of the air compressor. When selecting and installing, it is necessary to strictly follow the requirements of the equipment manual.

Replacement and Maintenance Suggestions: When the shaft sleeve shows excessive wear, scratches, cracks, or if the fit with the shaft exceeds the limit, it should be replaced immediately; otherwise, it may cause wear on the shaft neck, increased vibration, or abnormal noise from the equipment. When replacing, use original factory parts and ensure that the surface of the shaft and the bearing housing are cleaned before installation. If necessary, perform size checks according to the manual requirements. During installation, avoid knocking the shaft sleeve to cause deformation. If necessary, use professional techniques such as hot assembly to ensure the fit accuracy.

Installation and Maintenance Instructions Oil pipes inside the unit: Replace after shutdown, depressurization and cooling; Record the direction and connection sequence, clean the interfaces, assemble according to the specified torque; Recheck the pressure drop and leakage after operation. Gas pipelines: Avoid excessive bending / stretching and dragging on the ground; Regularly inspect the joints and wear; Perform a gas tightness test when necessary.

Atlas Copco 2202207986 is made of high-strength cast iron and steel. It has sufficient rigidity and wear resistance, and is suitable for the long-term high-speed operation range of 500 - 3000 rpm of the machinery.

The centrifugal cooling fan feature of Atlas Copco air compressor GA55: It adopts a low-speed centrifugal fan design, featuring high cooling air volume and low noise. The fan energy-saving cycle controls the fan's start/stop by monitoring the outlet temperature of the main unit and the ambient temperature. This not only saves energy but also prevents condensation water from forming in the GA VSD compressor when operating at low loads.PRICE INQUIRY

If you need to purchase or confirm the specific model, it is recommended to provide the equipment serial number of ZT55-90. Refer to the corresponding part number in the official Atlas Copco spare parts manual (usually a series of numbers, such as 1092xxx series), and obtain precise spare parts from the authorized service provider to ensure the stable operation and compliance of the equipment.