China 2902022207 ATSL 165 EXCHANGE KIT Manufacturer, Supplier, Factory

Maintenance and Replacement Precautions for the Bushings of Atlas Copco Air Compressors Original Factory Parts Preferred: It is recommended to use Atlas Copco's original bushings to ensure dimensional accuracy and material compatibility, avoiding secondary damage caused by sub-brand parts quality issues. Installation Precision: The replacement should be carried out by professional technicians. The interference fit between the bushing and the bearing housing, as well as the clearance between the bushing and the shaft neck, must be strictly controlled. Special tools may be used for press-fitting in necessary cases. Compliance Check: After installation, the rotor clearance should be detected using a feeler gauge or precise instruments to ensure it meets the technical standards. Lubrication Assurance: After replacement, the specific compressor oil should be added in accordance with the specifications. Before starting, ensure that the lubrication system is properly supplied with oil.

Selection and precautions for the oil-water separator of Atlas Copco G series air compressors The oil-water separator should be selected based on the specific model (such as G37, G75) and displacement of the G series air compressor to ensure that the processing capacity matches. It is recommended to use the original Atlas Copco oil-water separator and filter element. Their materials (such as the filter element using high-efficiency fiberglass or polyester materials) and structural design are fully compatible with the G series models, which can ensure separation efficiency and service life, and avoid secondary pollution or excessive pressure loss caused by compatibility issues.

Replacement and Maintenance: Gaskets are wear-prone parts. They should be checked and replaced promptly during regular maintenance of the air compressor or when leakage occurs. During the replacement process, ensure the installation surface is clean to avoid poor sealing due to impurities. Also, follow the specifications in the equipment manual for proper operation to ensure a proper installation.

The control unit of Atlas Copco's injection-type screw compressors is designed with intelligence, which not only simplifies operation management but also significantly improves the operating efficiency and reliability of the equipment. It is a key guarantee for achieving the "efficient, energy-saving, and safe" operation of the compressors. When choosing, it is necessary to match the corresponding specification of the control unit according to the compressor model and actual working conditions.

Replacement and Maintenance Precautions: If cracks, deformations, damage to the sealing parts, or worn-out connection threads occur on the shell, it must be replaced immediately. Otherwise, unfiltered air will directly enter the main unit, causing wear and tear on components such as rotors and bearings. During daily maintenance, it is necessary to check whether the seal between the shell and the filter element is intact, and clean the dust and impurities inside the shell (especially when replacing the filter element). When installing a new shell, ensure that the sealing ring is installed properly, and tighten the connecting bolts according to the specified torque to avoid air leakage or damage to the shell due to vibration.

The thermostat valve of the Atlas Copco 2205526520 oil injection type screw compressor is composed of a temperature sensing element, a valve, a valve core, spring components, sealing elements, and threaded connection ports. When the temperature of the compressor reaches the set value, the temperature sensing element triggers the valve core to open the cooling path of the cooler. Then, the lubricating oil is cooled and recirculated, which can prevent the oil from overheating and deteriorating in quality, as well as the formation of carbon deposits that cause the air compressor to have a higher temperature and affect its efficiency.