China 2901052300 Manufacturer, Supplier, Factory

Using the original Atlas Copco kit for maintenance can ensure that the compressor maintains the same performance and reliability as a new unit, as these original parts are specifically designed for air compressors and can guarantee that the equipment reaches the desired performance level, improving the machine's availability and service life. If you need more accurate kit contents and detailed information, it is recommended to provide the specific model and serial number of the air compressor so that the precise kit configuration can be queried through the official Atlas Copco channels.

Replacement and precautions for the oil filter housing of Atlas Copco screw-type air compressors Part matching: It is necessary to use the original Atlas Copco housing module to ensure complete matching with the model and filter cartridge model (for example, the housing specifications of different power models of the GA series are different). Installation guidelines: Clean the internal oil stains and impurities of the housing during replacement, and check if the sealing surface is flat. The new housing needs to be properly coated with sealant (if necessary) or installed with new O-rings to avoid leakage. Tighten the filter cartridge with the specified torque to prevent over-tightening from damaging the housing threads or under-tightening causing leakage. Regular inspection: During each oil filter cartridge replacement, simultaneously check for any cracks or deformations in the housing, whether the sealing parts are intact, and ensure the reliable operation of the oil circuit system.

Model and Purchase Suggestions Full part number: The part number of Atlas Copco's air filters usually consists of multiple digits (such as 1621735200, etc., and C142 might be its specification abbreviation), and the specific number should be based on the equipment manual or the body identification. Purchase Channel: It is recommended to query through Atlas Copco authorized service providers or the official website, providing the complete model of the equipment (such as GA110VSD+) and the factory serial number to ensure the precise compatibility of the accessories. Maintenance Cycle: Follow the recommendations in the VSD + model manual. Generally, it is recommended to replace the filters after 1500-3000 hours (adjust according to the dust concentration in the environment), or replace them promptly when the pressure difference indicator alarms.

Based on the general accessory information for this series of models, the relevant reference number for the vent hole kit of ZT15-22 may be: Some models use a ventilation assembly with the serial number 2901111500 (including ventilation plugs, sealing rings, etc.);

1604027401 Atlas Copco Purchase Recommendation: 1604027401 Atlas Copco exhaust pipes are wear-prone components. After long-term use, they may experience aging and damage, requiring regular inspection and maintenance. When replacing, it is recommended to use 1604027401 Atlas Copco original parts to ensure equipment performance and service life. These can be obtained through our authorized dealers.

Replacement and Maintenance Precautions If the components show signs of aging and cracking of the hose, leakage at the joints, damage to the reinforcement layer, or bulging, they must be replaced immediately to prevent leakage of high-pressure media, which could cause safety hazards or affect system operation; When replacing, it is essential to use the original Fx1050Xf type components to ensure that their dimensions, pressure resistance level, and joint sealing are consistent with the original components. Non-original components may cause installation difficulties or premature damage due to poor compatibility; During installation, pay attention to the bending radius of the hose (it must not be less than the specified value, usually 6-8 times the diameter of the hose), avoid excessive twisting or stretching, and keep away from high-temperature components and rotating parts. If necessary, use pipe clamps for fixation to reduce vibration and wear.