China 1089062120 Manufacturer, Supplier, Factory

An air compressor is a device that compresses air into high-pressure gas and stores it. Its function is to compress a large amount of gas (usually air) to a higher pressure, enabling it to be used in various industrial, manufacturing, and construction processes.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.

If you need to purchase Atlas Copco air compressor oil filter, please provide the specific model of the air compressor (such as GA18, G55) or the equipment serial number. Then, confirm the accurate model through the authorized service provider of Atlas Copco to avoid any issues due to incorrect model matching and ensure proper usage.

Atlas Copco GA26VSD is a variable-frequency screw air compressor in the GA series of Atlas Copco. It is specially designed for high efficiency, energy conservation, and flexible adaptation to different gas usage requirements, and is widely used in various industrial scenarios.

The high-pressure rotor replacement kit of Atlas Copco is mainly applicable to equipment such as high-pressure compressors of the Atlas Copco brand. When the high-pressure rotor of the equipment is worn out, damaged or reaches a certain service life, which affects the normal operation and compression efficiency of the equipment, this kit can be replaced to restore the performance of the equipment.

Failure causes and maintenance suggestions for Atlas Copco Air compressor O-ring Common failure causes: Long-term high-temperature aging leads to reduced elasticity, wear or scratches (such as impurities entering the sealing surface), improper installation (such as twisting, being too tight), incorrect selection (material not suitable for the medium or temperature). Maintenance precautions: Regularly inspect the condition of the O-ring. Replace it promptly if it shows signs of hardening, cracking, deformation or leakage. When replacing, clean the sealing groove and mating surface, remove oil stains, burrs and impurities. Avoid using sharp tools to scratch the O-ring during installation. If necessary, apply special lubricating grease (compatible with the medium) to assist in installation. Select matching specifications and materials for the O-ring based on the air compressor model and location.It is recommended to use original factory parts to ensure the sealing effect.