China Spare Parts Atlas Copco Original Manufacturer, Supplier, Factory

The V-shaped belt has the characteristics of simple structure, high transmission efficiency and convenient maintenance. It is suitable for equipment that requires stable power transmission, such as air compressors. In Atlas Copco air compressors, the specifications and models of the V-shaped belts vary according to the specific compressor model and power, in order to meet different transmission requirements.

2906066100 Atlas Copco's metal oil pump component service kit replacement and maintenance recommendations for the ZR/ZL 55-90 series screw air compressors When there are abnormal oil pump noises, fluctuating supply pressure, insufficient lubricating oil flow, or oil leakage in the oil circuit, it is recommended to check the oil pump status and use this service kit for maintenance. During the replacement process, strictly follow the procedures in the equipment manual to operate and ensure the correct installation of the components, and conduct a pressure test after the repair to confirm that the performance of the oil pump has returned to normal.

Atlas Copco Full Stainless Steel Gear Wheel Maintenance and Precautions Lubrication Guarantee: It should be used in conjunction with dedicated gear oil to ensure that the meshing surfaces of the gears are fully lubricated, reducing wear caused by dry friction; regularly check the oil level and condition of the lubricant and replace it according to the specified cycle. Regular Inspection: During operation, pay attention to observing whether there are abnormal noises, vibrations or temperature increases at the gear transmission parts. This may indicate gear wear, poor meshing or bearing problems, and it is necessary to stop the machine for inspection in time. Replacement Specifications: When replacing, use the original full stainless steel gear wheel to ensure that the installation dimensions, module, and tooth count of the new gear wheel are completely matched with the original model; during installation, ensure the coaxiality of the gear shaft to avoid early damage due to installation deviation.

Atlas Copco Air Compressor Oil Check Valve Maintenance and Replacement Check Period: It is recommended to conduct checks every 1-2 years or in accordance with the equipment manual (for example, after 4000-8000 hours of operation), and perform the checks simultaneously when replacing the filter and oil. Maintenance Points: Clean the valve core and valve seat to remove impurities; Check the wear of the seals and replace them promptly if they are aged; Test the elasticity of the springs. If the elasticity is insufficient, replace the entire valve. Replacement Precautions: Select original factory parts that match the model (such as Atlas Copco, Ingersoll Rand, etc. have dedicated oil check valves). Ensure that the size and pressure parameters are consistent; Pay attention to the direction during installation, and avoid installing it in the wrong direction; After replacement, start the equipment and check if the oil circuit pressure is normal and if there is any leakage.

The component design of Atlas Copco dryers emphasizes compatibility with air compressor systems. By optimizing heat exchange efficiency, adsorbent performance and automatic control logic, it achieves low energy consumption and high stability in the drying process of compressed air.

Maintenance and Common Issues of 40°C Thermostat for Atlas Copco Air Compressors Regular Calibration: After long-term use, temperature drift may occur. It is recommended to calibrate with a thermometer annually to ensure accurate triggering at 40°C. Cleaning and Maintenance: If the sensing part is covered with oil or dust, it will affect the sensitivity of temperature measurement. It is necessary to wipe it regularly (operate in power-off state). Common Faults: Temperature Trigger Deviation: This may be due to the aging of the sensing element. Replacement of the same model thermostat is required. Contact Adhesion: Causes the cooling equipment to run continuously or fail to start. Check the contact condition and replace it if necessary.