China atlas copco air compressor manual Manufacturer, Supplier, Factory

For the high-pressure rotor balance diaphragms of Atlas Copco air compressors, if you need to purchase or confirm the specific model, it is recommended to provide the complete model of the compressor (such as ZT75, ZH110) and the rotor component number. Then, through the official after-sales service channel, query the compatible balance diaphragm model to ensure the stability and safety of the equipment operation.

The electromagnetic valve maintenance kit for Atlas Copco EWD330 electronic drainage valve is applicable for maintenance suggestions. Applicable models: Only applicable to Atlas Copco EWD330 type electronic drainage valve. Before purchase, it is necessary to confirm the production batch and electromagnetic valve specification of the drainage valve to avoid model mismatch. Maintenance timing: When the drainage valve shows slow operation, abnormal drainage , abnormal noise from the electromagnetic valve, or air leakage, it may be necessary to repair the electromagnetic valve. At this time, this kit can be used to replace the worn parts. Installation note: It is recommended to operate by professionals. Before maintenance, cut off the power and air source, assemble in accordance with the original factory manual specifications, ensure that the components are installed properly, and avoid functional failure or safety hazards due to improper assembly.

Atlas Copco Ventilation Pipe Component Application and Maintenance Recommendations Application Scenario: Primarily used for the ventilation system setup in air compressor rooms, especially in enclosed or poorly ventilated environments, where the use of ventilation pipe components is necessary to optimize air circulation and maintain the room temperature within the equipment's allowable range (generally recommended not to exceed 40℃). Maintenance Points: Regularly inspect the ventilation pipes for any damage, deformation, or loose connections to ensure there is no air leakage; Clean the dust accumulation in the pipes to prevent blockages that affect air volume; For flexible connection pipes, check for aging, cracking, and replace them in a timely manner to ensure their elasticity and sealing performance.

Atlas Copco Air Compressor Oil Separation Filter Purchase Recommendation To ensure the separation effect and equipment safety, it is recommended to purchase the original factory oil separation cores through our authorized dealers. Using inferior substitute filters may result in insufficient separation efficiency, short lifespan, and even damage to the main unit, thereby increasing maintenance costs. The performance of the oil separation filter directly affects the operating efficiency, energy consumption, and downstream gas quality of the air compressor. It is a component that needs to be focused on during maintenance.

Maintenance and replacement instructions for the transmission shaft seal kit of Atlas Copco screw air compressors If oil stains or oil leakage are observed near the transmission shaft, or if the consumption of compressor lubricating oil increases abnormally, it may be due to the aging or damage of the seal kit. Therefore, it is necessary to check and replace it in time. When replacing, it is recommended to use the original kit and operate in accordance with the equipment manual to ensure that the seal is installed in the correct direction and tightly attached. In case of necessity, special tools can be used for installation to avoid deformation or damage to the seal.

Function: Filtering impurities: During the operation of the air compressor, the lubricating oil will generate metal debris due to friction with metal components, and the oil itself will also produce gums and other impurities due to heating and oxidation with air. The oil filter can effectively remove these impurities, such as metal particles and deteriorated oil substances. The filtration accuracy is usually between 5-15 μm, maintaining the cleanliness of the oil passage, preventing impurities from entering critical components such as bearings, gears, and main body cavities, reducing wear and extending the service life of the equipment. Ensuring lubrication effect: Ensure that the oil entering the main unit is pure, maintain good lubrication performance, allow the friction surfaces to be fully lubricated, reduce friction loss, and avoid faults caused by poor lubrication due to impurities, such as bearing damage, rotor seizing, etc.