China 2906067800 Atlas Copco Manufacturer, Supplier, Factory

Atlas Copco confirms the type of lubricating grease Based on the type of air compressor components and operating conditions , select the matching special lubricating grease . It is strictly prohibited to mix different types or grades of lubricating grease . Check the parameters of the lubricating grease: such as applicable temperature range, pour point , and penetration . Atlas Copco cleans the components to be lubricated Stop the machine and ensure the components are completely cooled. Use oil-free cotton cloth or dedicated cleaning agents to wipe the old lubricating grease, oil stains, dust, and metal debris on the surface of the components, especially the key areas such as the bearing seat and the meshing surface of the gears, which need thorough cleaning .

Replacement and Maintenance Precautions Cycle Compliance: Follow the specified cycle in the equipment manual for replacement (e.g., air filter every 2000 - 4000 hours, oil-gas separator every 8000 - 12000 hours). In harsh environments (dusty, high temperature), check and replace in advance. Installation Specifications: Release system pressure before replacement and clean the interior of the filter housing. The sealing parts of the new filter need to be coated with clean lubricating oil (for oil filter) or compressed air (for air filter) to ensure a reliable seal. Tighten the end cover or housing with the specified torque to avoid over-tightening which may damage the shell or under-tightening which may lead to leakage. Kit Integrity: The original factory kit includes all necessary components (such as sealing parts, small gaskets), and when replacing, all components must be updated. Do not mix and use old parts.

Structural composition Valve body: The main body that connects the oil circuit, usually having an oil inlet, a direct outlet, and an outlet for the cooler. Thermosensitive element: The core component, which expands or contracts with temperature changes. Spring: Cooperates with the thermosensitive element to control the opening and closing degree of the valve. Valve core / Valve rod: The actuating mechanism, which regulates the oil flow direction according to the signal from the thermosensitive element.

The high-pressure rotor replacement kit of Atlas Copco is mainly applicable to equipment such as high-pressure compressors of the Atlas Copco brand. When the high-pressure rotor of the equipment is worn out, damaged or reaches a certain service life, which affects the normal operation and compression efficiency of the equipment, this kit can be replaced to restore the performance of the equipment.

Quick selection steps: Determine whether to use the "gas side" or the "oil side". Provide key parameters: model / serial number, flow / pipe diameter, pressure rating, temperature, target cleanliness / emission limit. If there is an old part number / nameplate, directly provide for precise matching.

Troubleshooting and Replacement Suggestions: Common Issues and Solutions: Stalling or Leakage: Causes unstable pressure and increased energy consumption. It is recommended to disassemble and clean or replace directly (it is suggested to replace the entire set to avoid matching issues between new and old components). Reduced Adjustment Precision: Mostly due to wear of sensors or valve cores. Replacement of the original kit is required and recalibration is necessary. Installation Tips: After replacement, parameter matching through the controller (such as setting pressure upper and lower limits) is necessary to ensure normal system linkage.